Re: wm devices don't work under current amd64

[Masanobu SAITOH <msaitoh%execsw.org@localhost>]

Hi, Tom.

On 2016/03/07 20:42, Tom Ivar Helbekkmo wrote:
> Masanobu SAITOH <msaitoh%execsw.org@localhost> writes:
>
> >   0) Did you check /var/log/message if device timouts occured?
>
> No timeouts.  Everything behaves as if there were no incoming traffic.
>
> >   1) Is Intel AMT set to enable by BIOS?
>
> No, it's not.
>
> >   2) Could you show me the output of "ifconfig -v wm0"
>
> wm0: flags=0x8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
> 	capabilities=7ff80<TSO4,IP4CSUM_Rx,IP4CSUM_Tx,TCP4CSUM_Rx>
> 	capabilities=7ff80<TCP4CSUM_Tx,UDP4CSUM_Rx,UDP4CSUM_Tx,TCP6CSUM_Rx>
> 	capabilities=7ff80<TCP6CSUM_Tx,UDP6CSUM_Rx,UDP6CSUM_Tx,TSO6>
> 	enabled=0
> 	ec_capabilities=7<VLAN_MTU,VLAN_HWTAGGING,JUMBO_MTU>
> 	ec_enabled=0
> 	address: 00:26:b9:cd:21:c2
> 	media: Ethernet 100baseTX full-duplex

 Is the port connecting 100BaseT switch or gigabit switch.

> 	status: active
> 	input: 0 packets, 0 bytes

 Strange.

> 	output: 20 packets, 2608 bytes, 9 multicasts
> 	inet 169.254.22.67 netmask 0xffff0000 broadcast 169.254.255.255

 Are you using dhcpcd? Have you tried with static IPv4 address?
And, could you try "ping6 ff02::1%wm0" and check if any reply
comes from other machine?

 One of the possibility is that the multicast filter table and broadcast
bit in a register aren't set correctly on ICH9.

 Regards.

> 	inet6 fe80::226:b9ff:fecd:21c2%wm0 prefixlen 64 scopeid 0x1
>
> >   Is it possible to test with 7.0(RELEASE) and the latest snapshot
> > of netbsd-7 branch?
>
> I'll burn a couple of CDs, and try those tonight.
>
> -tih


--
-----------------------------------------------
                SAITOH Masanobu (msaitoh%execsw.org@localhost
                                 msaitoh%netbsd.org@localhost)