[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]
Re: ikphy negotiation problem with cisco
Mon, Apr 05, 2010 at 03:03:49PM +0900, SAITOH Masanobu:
> From: Manuel Bouyer <bouyer%antioche.eu.org@localhost>
> Subject: Re: ikphy negotiation problem with cisco
> Date: Thu, 1 Apr 2010 15:28:46 +0200
> > On Wed, Mar 31, 2010 at 08:34:52PM +0000, john heasley wrote:
> >> I have a new board (Supermicro X7DVA-8/X7DVA-E) with a dual interface
> >> as indicated below. The problem is that this interfaces refuses to
> >> auto-negotiate with a cisco 6500 gige port. The only way to get link
> >> is auto-neg on the wm and hard-configured 100m/half duplex.
> >> Does anyone have this mac / phy combination that is working?
> > I have several of this one:
> > wm0 at pci4 dev 0 function 0: i80003 dual 1000baseT Ethernet, rev. 1
> > wm0: interrupting at ioapic0 pin 18, event channel 6
> > wm0: PCI-Express bus
> > wm0: 65536 word (16 address bits) SPI EEPROM
> > wm0: Ethernet address 00:30:48:31:43:82
> > ikphy0 at wm0 phy 1: i82563 10/100/1000 media interface, rev. 2
> > ikphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> > 1000baseT-FDX, auto
> > It negociates properly with a 100baseTX or 1000baseT port of a
> > cisco 3750 serie switch.
> > This is with a netbsd-5 kernel, sources around the 17 March
> > --
> > Manuel Bouyer <bouyer%antioche.eu.org@localhost>
> > NetBSD: 26 ans d'experience feront toujours la difference
> > --
> My own box has only one interface and works fine, too.
> wm0 at pci4 dev 0 function 0: i80003 dual 1000baseT Ethernet, rev. 1
> wm0: interrupting at ioapic0 pin 18
> wm0: PCI-Express bus
> wm0: 65536 word (16 address bits) SPI EEPROM
> wm0: Ethernet address 00:13:d3:c0:3c:7c
> ikphy0 at wm0 phy 1: i82563 10/100/1000 media interface, rev. 2
> ikphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> 1000baseT-FDX, auto
> John, do both interface have the problem? Does the problem occurs any switch
> and hub?
I do not know; the machine is hundreds of miles away and remote hands are
difficult to arrange. I haven't tried the second interface with this
switch nor tried any other GE switches. When I installed netbsd, it was
connected to a 10/100 cisco. It worked fine, but I do not recall if it
negotiated full-duplex or not.
If I watch the switch and machine closely (repeat the commands), they
seem to agree on 1000/FD, then reset, repeat.
Main Index |
Thread Index |