re: CVS commit: src

[matthew green <mrg%eterna.com.au@localhost>]

> - Add the following cards' support:
>       [ .... ]
>       NetMos NM9901 PCIe (single parallel)

do you have one of these cards?  i've got one i haven't gotten working
yet, except mine is a serial port, not a parallel port.  all the other
drivers for it seem to attach it as a single serial port too.

however, neither your configuration nor the one i've worked on so far
work for my card -- a dual 9901 expresscard, that attaches like this:

        puc0 at pci4 dev 0 function 0: NetMOS 9901 (com)
        com2 at puc0 port 0: interrupting at ioapic0 pin 19
        com2: ns16550a, working fifo
        puc1 at pci4 dev 0 function 1: NetMOS 9901 (com)
        com3 at puc1 port 0: interrupting at ioapic0 pin 16
        com3: ns16550a, working fifo

with your configuration, it doesn't attach, due to the sub-vendor
and sub-productid's not matching for me.  this entry:

   {   PCI_VENDOR_NETMOS,      0x9901, 0xa000, 0x2000  },
   {   0xffff, 0xffff, 0xffff, 0xffff  },
   {
       { PUC_PORT_TYPE_LPT, 0x10, 0x00, 0x00 },

doesn't match, and if i make it look like:

   {   PCI_VENDOR_NETMOS, PCI_PRODUCT_NETMOS_NM9901, 0, 0 }
   {   0xffff, 0xffff, 0,      0       },
   {
       { PUC_PORT_TYPE_COM, 0x10, 0x00, 0x00 },

it fails when trying to open with kermit:

    (/home/mrg/) C-Kermit>set line /dev/tty02
    tcsetattr: Invalid argument

this 

   {   PCI_VENDOR_NETMOS, PCI_PRODUCT_NETMOS_NM9901, 0, 0 }
   {   0xffff, 0xffff, 0,      0       },
   {
       { PUC_PORT_TYPE_COM, 0x10, 0x00, COM_FREQ * 8 },

attaches, and kermit is able to open the device, but kermit
disconnects when you try to actually "connect":

(/usr/src/) C-Kermit>set line /dev/tty02
(/usr/src/) C-Kermit>set sp 115200
/dev/tty02, 115200 bps
(/usr/src/) C-Kermit>c
Connecting to /dev/tty02, speed 115200
 Escape character: Ctrl-\ (ASCII 28, FS): enabled
Type the escape character followed by C to get back,
or followed by ? to see other options.
?Carrier required but not detected.
***********************************
[ ... ]

i've tried to "set carrier-watch off" in kermit, but it still
disconnects immediately.

ah, the reason my card does not match normally is that the
subsystem ID is 0x1000 not 0x2000.


.mrg.