Port-sparc64 archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: Upgrading from 5.1_STABLE to 5.99.46 on Sun Fire V100



Am 23.02.2011 um 22:57 schrieb Rafal Boni:

> Folks:
>       I attempted to upgrade my V100 running 5.1_STABLE to -current as of
I did the same on a V120
>       2/22/2011 and ran into the following issues:
> 
>       1. tlp0 / tlp1 come up with MAC address of 00:00:00:00:00:00.
gem ist still fine
gem1: Ethernet address 00:03:ba:2a:8f:56, 2KB RX fifo, 2KB TX fifo
>       2. raid0 and raid1 (both auto-configured; raid0 root, raid1 not)
I do not yet have raid configured on this box, but there is something going on 
with raidframe...
>       3. spdmem* / admtemp* don't auto-probe at iic0 at alipm0:
> 
>          My netbsd-5 kernel had hard-wired spdmemX entries at 0x54-56 on
>          the IIC bus off the system controller and an amdtempX at 0x18.
> 
>          My -current kernel config was a stock sparc64 GENERIC with
>          DIAGNOSTIC / LOCKDEBUG added; the only things I see on iic0
>          are:
> 
>    ppm at iic0 addr 0x59 not configured
>    beep at iic0 addr 0x59 not configured
>    fan-control at iic0 addr 0x64 not configured

Mine do also not probe:
before:
iic0 at alipm0: I2C bus
spdmem0 at iic0 addr 0x54
spdmem1 at iic0 addr 0x55
spdmem2 at iic0 addr 0x56
spdmem3 at iic0 addr 0x57
admtemp0 at iic0 addr 0x18: ADM1021 or compatible environmental sensor

after:
iic0 at alipm0: I2C bus
fan-control at iic0 addr 0x64 not configured

What happened?
And, what is fan-control?

Cheers
        Oskar


Home | Main Index | Thread Index | Old Index