Set 100Mb card not working on 5.0

[George Harvey <fr30%dial.pipex.com@localhost>]

Hi,

I have a Set Engineering 100Mb Ethernet card which looks like it's not
being fully recognised by NetBSD 5.0. The machine is a R4400 Challenge S
and the card shows up as:

giopci0 at gio0 slot 1 addr 0x1f400000: Set Engineering GFE 10/100
Ethernet pci0 at giopci0 bus 0
pci0: memory space enabled
tl0 at pci0 dev 0 function 0
tl0: Texas Instruments ThunderLAN
tl0: Ethernet address 08:00:69:02:9e:21
tl0: interrupting at slot EXP0

I would then expect to see a media interface line something like
'nsphy at tl0' but it doesn't appear. If I try to use the card, I find I
can configure an IP address but I don't get a link light on my switch.

Looking back in my mail archive, I see that I previously tried this card
on 4.0_BETA2. Back then there were some transmit issues but the media
interfaces did show up as:

nsphy0 at tl0 phy 4: DP83840 10/100 media interface, rev. 0
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
tlphy0 at tl0 phy 31: ThunderLAN 10BASE-T media interface, rev. 4
tlphy0: 10baseT, 10baseT-FDX, auto

George