Re: Regarding NetBSD-current on Raspberry Pi 3

[Neeraj Pal <neerajpal09%gmail.com@localhost>]

Thanks for your feedback and help.

And, I think I will also try to upgrade NetBSD-8 to NetBSD-current
then I will try to look at dmesg and all logs.

I don't whether it will work or not but I will try.

On Tue, Jun 26, 2018 at 5:07 PM, Greg Troxel <gdt%lexort.com@localhost> wrote:
>
> Neeraj Pal <neerajpal09%gmail.com@localhost> writes:
>
>> So, I am installing -current in Raspberry Pi 3 by using the image,
>> "evbarm-earmv7hf" and also this one, "evbarm-earmv6hf" from
>> "http://nyftp.netbsd.org/pub/NetBSD-daily/HEAD/201806250640Z/";, but on
>> both of the image serial console is not working. And, I did the same
>> with FreeBSD just to verify the functioning of my USB-TTL and it is
>> working fine with FreeBSD.
>>
>> And, I have also removed the framebuffer switching from cmdline.txt,
>> but still it is not working.
>>
>> Then, I have downloaded the NetBSD-8 ("evbarm-earmv6hf") and then I
>> found that serial console is working fine with NetBSD-8 image.
>>
>> Here, in NetBSD-8 also I need to remove the framebuffer switching line
>> from cmdline.txt, after that everything works fine (only with
>> NetBSD-8).
>
> It sounds like you found a real problem.
>
> I would try to complete the install using NetBSD 8, and set up
> networking and sshd, and then swap in the current kernel and boot, and
> see if you can ssh in and look at dmesg.



-- 

Thank you!
Sincere regards;

Neeraj Pal