Re: No ethernet card with Olimex Lime 2

[Sujit K M <sjt.kar%gmail.com@localhost>]

> In all situations, I got the following, one or two times in dmesg output :
> awge0 at awinio0: Gigabit Ethernet Controller
> awge0: interrupting on irq 117
> awge0: reset timed out

Could you please share your ipconfig command.

>
>
> I use the lime2 uboot available at :
> http://dl.linux-sunxi.org/nightly/u-boot-sunxi/u-boot-sunxi-mainline/u-boot-sunxi-mainline-latest/
>
> and the following uboot commands since the uEnx.txt is not taken into account
> by uboot :
>
> setenv bootargs root=ld0a sysconfig=0x43000000
> fatload mmc 0:1 43000000 a20-olinuxino_lime2.bin
> fatload mmc 0:1 82000000
> netbsd.ub; bootm 82000000
>
> I don't know what's going on ... Any ideas ?

These are for Linux I guess.

>
>
>> Hi,
>>
>> > On 24 May 2015, at 18:20 , Picani <picani%laposte.net@localhost> wrote:
>> >
>> > Does anyone have the ethernet card working for this board ?
>>
>> You must use the lime2 uboot, found here:
>>
>> http://dl.linux-sunxi.org/nightly/u-boot-sunxi/u-boot-sunxi-mainline/u-boot-> sunxi-mainline-latest/
>>
>> The board should boot fine (with ethernet) with it.
>>
>> You can also replace the fex script by the one for lime2 (must be compiled
>> with sunxi tools), but it is not mandatory.
>>
>>
>> The full script is here:
>> https://github.com/linux-sunxi/sunxi-boards/tree/master/sys_config/a20
>>
>> But as I’m unable to boot with the full fex script, I shrinked it to the
>> minimum for NetBSD:
>



-- 
-- Sujit K M

blog(http://kmsujit.blogspot.com/)