Re: Installing NetBSD on DS10 Failing

[Rin Okuyama <rokuyama.rk%gmail.com@localhost>]

On 2024/03/29 11:24, Jason Thorpe wrote:
> Do you have a DS10? Can you send me a dmesg?

Sure, this dmesg is little bit stale, but the machine is in
the working condition :)

Thanks,
rin

consinit: not using prom console
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003,
    2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013,
    2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 10.99.4 (GENERIC-$Revision: 1.418 $) #7: Fri Jul  7 21:19:14 JST 2023
	rin@latipes:/home/rin/repos/src/sys/arch/alpha/compile/DS10
COMPAQ AlphaServer DS10 466 MHz, s/n 
8192 byte page size, 1 processor.
total memory = 2048 MB
(2976 KB reserved for PROM, 2045 MB used by NetBSD)
avail memory = 2002 MB
timecounter: Timecounters tick every 0.976 msec
Kernelized RAIDframe activated
mainbus0 (root)
cpu0 at mainbus0: ID 0 (primary), 21264-4 (EV6)
cpu0: Architecture extensions: 0x303<PAT,MVI,FIX,BWX>
tsc0 at mainbus0: 21272 Core Logic Chipset, Cchip rev 0
tsc0: 2 Dchips, 1 memory bus of 16 bytes
tsc0: arrays present: 1024MB, 1024MB, 0MB, 0MB, Dchip 0 rev 1
tsp0 at tsc0
pci0 at tsp0 bus 0
pci0: i/o space, memory space enabled, rd/line, rd/mult, wr/inv ok
sio0 at pci0 dev 7 function 0: Acer Labs M1533 PCI-ISA Bridge (rev. 0xc3)
tlp0 at pci0 dev 9 function 0: DECchip 21143 Ethernet, pass 4.1
tlp0: interrupting at dec 6600 irq 29
tlp0: DEC, Ethernet address 08:00:2b:87:2a:9b
tlp0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
tlp1 at pci0 dev 11 function 0: DECchip 21143 Ethernet, pass 4.1
tlp1: interrupting at dec 6600 irq 30
tlp1: DEC, Ethernet address 08:00:2b:87:2f:7b
tlp1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
aceride0 at pci0 dev 13 function 0: Acer Labs M5229 UDMA IDE Controller (rev. 0xc1)
aceride0: bus-master DMA support present, but unused (forced off by config file)
aceride0: primary channel wired to compatibility mode
aceride0: primary channel interrupting at isa irq 14
atabus0 at aceride0 channel 0
aceride0: secondary channel wired to compatibility mode
aceride0: secondary channel interrupting at isa irq 15
atabus1 at aceride0 channel 1
ppb0 at pci0 dev 14 function 0: PLX Technology PEX 8112 PCIe-to-PCI Bridge (rev. 0xaa)
ppb0: PCI Express capability version 1 <PCI/PCI-X to PCI-E Bridge> x1 @ 2.5GT/s
pci1 at ppb0 bus 2
pci1: i/o space, memory space enabled, rd/line, wr/inv ok
ixg0 at pci1 dev 0 function 0: Intel(R) PRO/10GbE PCI-Express Network Driver, Version - 4.0.1-k
ixg0: clearing prefetchable bit
ixg0: device X550
ixg0: NVM Image Version 1.86, PHY FW Revision 2.0b ID 0xb, NVM Map version 1.86, OEM NVM Image version 0.02, ETrackID 80000c66
ixg0: PBA number H92506-005
ixg0: interrupting at dec 6600 irq 35
ixg0: Ethernet address b4:96:91:45:e9:ae
ixg0: PHY: Intel X550 100M/1G/10G media interface, rev. 0
ixg0: PCI Express Bus: Speed 2.5GT/s Width x1
ixg0: PCI-Express bandwidth available for this card
     is not sufficient for optimal performance.
ixg0: For optimal performance a x8 PCIE, or x4 PCIE Gen2 slot is required.
ixg0: feature cap 0x17a0<TEMP_SENSOR,LEGACY_TX,FDIR,MSI,MSIX,LEGACY_IRQ>
ixg0: feature ena 0x1020<TEMP_SENSOR,LEGACY_IRQ>
wm0 at pci0 dev 15 function 0, 64-bit DMA: Intel i82546GB 1000BASE-T Ethernet (rev. 0x03)
wm0: interrupting at dec 6600 irq 39
wm0: 64-bit 33MHz PCI bus
wm0: 256 words (8 address bits) MicroWire EEPROM
wm0: Ethernet address 00:04:23:c3:96:ac
wm0: 0x802<LOCK_EECD,BUS64>
makphy0 at wm0 phy 1: Marvell 88E1011 Gigabit PHY, rev. 5
makphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
wm1 at pci0 dev 15 function 1, 64-bit DMA: Intel i82546GB 1000BASE-T Ethernet (rev. 0x03)
wm1: interrupting at dec 6600 irq 38
wm1: 64-bit 33MHz PCI bus
wm1: 256 words (8 address bits) MicroWire EEPROM
wm1: Ethernet address 00:04:23:c3:96:ad
wm1: 0x802<LOCK_EECD,BUS64>
makphy1 at wm1 phy 1: Marvell 88E1011 Gigabit PHY, rev. 5
makphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
ppb1 at pci0 dev 16 function 0: Pericom Semiconductors PI7C9X111SL PCIe to PCI Reverse Bridge (rev. 0x02)
ppb1: PCI Express capability version 1 <PCI/PCI-X to PCI-E Bridge> x1 @ 2.5GT/s
pci2 at ppb1 bus 3
pci2: i/o space, memory space enabled, rd/line, wr/inv ok
twa0 at pci2 dev 0 function 0: 3ware 9650SE series (rev. 0x01)
twa0: 64-bit DMA addressing active
twa0: interrupting at dec 6600 irq 43
twa0: 2 ports, Firmware FE9X 4.10.00.007, BIOS BE9X 4.08.00.002
twa0: Monitor BL9X 3.08.00.001, PCB Rev 032 , Achip 1.90    , Pchip 2.00    
twa0: port 1: WDC  WDS500G1R0A-68A4W0                  476940 MB
twa0: AMCC    9650SE-2LP DISK 4.1002A00D0B6D9E9F001667
ld0 at twa0 unit 0
ld0: 465 GB, 60786 cyl, 255 head, 63 sec, 512 bytes/sect x 976541696 sectors
isa0 at sio0
lpt0 at isa0 port 0x3bc-0x3bf irq 7
com0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, 16-byte FIFO
com0: console
com1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, 16-byte FIFO
pckbc0 at isa0 port 0x60-0x64
attimer0 at isa0 port 0x40-0x43
pcppi0 at isa0 port 0x61
spkr0 at pcppi0: PC Speaker
wsbell at spkr0 not configured
midi0 at pcppi0: PC speaker
isabeep0 at pcppi0
fdc0 at isa0 port 0x3f0-0x3f7 irq 6 drq 2
mcclock0 at isa0 port 0x70-0x71: mc146818 compatible time-of-day clock
attimer0: attached to pcppi0
tsciic0 at tsc0
iic0 at tsciic0: I2C bus
timecounter: Timecounter "PCC" frequency 462369600 Hz quality 1000
timecounter: Timecounter "clockinterrupt" frequency 1024 Hz quality 0
WARNING: system needs entropy for security; see entropy(7)
stray isa irq 14
wd0 at atabus0 drive 0
wd0: <SanDisk SSD PLUS 120 GB>
wd0: drive supports 1-sector PIO transfers, LBA48 addressing
wd0: 111 GB, 232594 cyl, 16 head, 63 sec, 512 bytes/sect x 234455040 sectors
wd0: 32-bit data port
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 6 (Ultra/133)
wd0(aceride0:0:0): using PIO mode 4
crypto: assign driver 0, flags 2
crypto: driver 0 registers alg 1 flags 0 maxoplen 0
crypto: driver 0 registers alg 2 flags 0 maxoplen 0
crypto: driver 0 registers alg 3 flags 0 maxoplen 0
crypto: driver 0 registers alg 4 flags 0 maxoplen 0
crypto: driver 0 registers alg 5 flags 0 maxoplen 0
crypto: driver 0 registers alg 26 flags 0 maxoplen 0
crypto: driver 0 registers alg 27 flags 0 maxoplen 0
crypto: driver 0 registers alg 29 flags 0 maxoplen 0
crypto: driver 0 registers alg 33 flags 0 maxoplen 0
crypto: driver 0 registers alg 17 flags 0 maxoplen 0
crypto: driver 0 registers alg 6 flags 0 maxoplen 0
crypto: driver 0 registers alg 19 flags 0 maxoplen 0
crypto: driver 0 registers alg 7 flags 0 maxoplen 0
crypto: driver 0 registers alg 20 flags 0 maxoplen 0
crypto: driver 0 registers alg 15 flags 0 maxoplen 0
crypto: driver 0 registers alg 24 flags 0 maxoplen 0
crypto: driver 0 registers alg 25 flags 0 maxoplen 0
crypto: driver 0 registers alg 8 flags 0 maxoplen 0
crypto: driver 0 registers alg 21 flags 0 maxoplen 0
crypto: driver 0 registers alg 16 flags 0 maxoplen 0
crypto: driver 0 registers alg 9 flags 0 maxoplen 0
crypto: driver 0 registers alg 10 flags 0 maxoplen 0
crypto: driver 0 registers alg 13 flags 0 maxoplen 0
crypto: driver 0 registers alg 14 flags 0 maxoplen 0
crypto: driver 0 registers alg 28 flags 0 maxoplen 0
crypto: driver 0 registers alg 30 flags 0 maxoplen 0
crypto: driver 0 registers alg 31 flags 0 maxoplen 0
crypto: driver 0 registers alg 32 flags 0 maxoplen 0
crypto: driver 0 registers alg 11 flags 0 maxoplen 0
crypto: driver 0 registers alg 18 flags 0 maxoplen 0
crypto: driver 0 registers alg 23 flags 0 maxoplen 0
crypto: driver 0 registers alg 22 flags 0 maxoplen 0
swwdog0: software watchdog initialized
entropy: best effort
root on ixg0
nfs_boot: trying DHCP/BOOTP
ixg0: Link is Down
ixg0: Link is up 10 Gbps Full Duplex 
ixg0: Link is Down
ixg0: Link is up 10 Gbps Full Duplex 
nfs_boot: DHCP next-server: 192.168.0.1
nfs_boot: my_name=ds10
nfs_boot: my_domain=local
nfs_boot: my_addr=192.168.0.11
nfs_boot: my_mask=255.255.0.0
nfs_boot: gateway=192.168.10.1
root on 192.168.0.1:/exports/ds10
root file system type: nfs
kern.module.path=/stand/alpha/10.99.4/modules