NetBSD-Bugs archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: port-arm32/50288 (NetBSD-7.0_RC3/evbarm-earmv7hf/binary/gzimg/armv7.img doesn't boot on BBB)

The following reply was made to PR port-arm32/50288; it has been noted by GNATS.

From: (Michael van Elst)
Subject: Re: port-arm32/50288 (NetBSD-7.0_RC3/evbarm-earmv7hf/binary/gzimg/armv7.img doesn't boot on BBB)
Date: Thu, 12 Nov 2015 12:27:41 +0000 (UTC) ("David S. Alessio") writes:
 >There=E2=80=99s still a problem with reading/booting from the SD card.
 >I tried netbsd-7/201511091230Z/evbarm-earmv7hf/binary/gzimg/arm7.img.gz:
 BBB boots -current (not netbsd-7) here from an SD card without problems.
 There is a single 'sdhc1: cmd timeout error' because one command
 fails when probing the on-board card.
 Maybe your errors are SD-card related?
 ## Transferring control to NetBSD stage-2 loader (at address 80300000) ...
 uboot arg = 0x9f238fe0, 0, 0x9f3a1235, 0x9f2405e0
 [ Kernel symbol table missing! ]
 Loaded initial symtab at 0x8061e268, strtab at 0x8064f3b8, # entries 12547
 Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
     2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
     The NetBSD Foundation, Inc.  All rights reserved.
 Copyright (c) 1982, 1986, 1989, 1991, 1993
     The Regents of the University of California.  All rights reserved.
 NetBSD 7.99.21 (BLA) #29: Tue Nov  3 08:13:07 CET 2015
 total memory = 512 MB
 avail memory = 500 MB
 sysctl_createv: sysctl_create(machine_arch) returned 17
 timecounter: Timecounters tick every 10.000 msec
 mainbus0 (root)
 cpu0 at mainbus0 core 0: 550 MHz Cortex-A8 r3p2 (Cortex V7A core)
 cpu0: DC enabled IC enabled WB disabled EABT branch prediction enabled
 cpu0: sctlr: 0xc5187d
 cpu0: actlr: 0x42
 cpu0: revidr: 0x413fc082
 cpu0: isar: [0]=0x101111 [1]=0x13112111 [2]=0x21232031 [3]=0x11112131, [4]=0x11142, [5]=0
 cpu0: mmfr: [0]=0x1100003 [1]=0x20000000 [2]=0x1202000 [3]=0x211
 cpu0: pfr: [0]=0x1131 [1]=0x11
 cpu0: 32KB/64B 4-way L1 VIPT Instruction cache
 cpu0: 32KB/64B 4-way write-back-locking-C L1 PIPT Data cache
 cpu0: 256KB/64B 8-way write-through L2 PIPT Unified cache
 vfp0 at cpu0: NEON MPE (VFP 3.0+), rounding, NaN propagation, denormals
 vfp0: mvfr: [0]=0x11110222 [1]=0x11111
 obio0 at mainbus0 base 0x44000000-0x4fffffff: On-Board IO
 omapicu0 at obio0 addr 0x48200000-0x48200fff intrbase 0
 prcm0 at obio0 addr 0x44e00000-0x44e01fff: Power, Reset and Clock Management
 sitaracm0 at obio0 addr 0x44e10000-0x44e11fff: control module, rev 1.0
 edma0 at obio0 addr 0x49000000-0x490fffff intrbase 12
 gpmc0 at mainbus0 base 0x50000000: General Purpose Memory Controller, rev 6.0
 gpmc0: CS#0 valid, addr 0x08000000, size 256MB
 com0 at obio0 addr 0x44e09000-0x44e09fff intr 72: ns16550a, working fifo
 com0: console
 sdhc0 at obio0 addr 0x48060100-0x48060fff intr 64sdhc0: EDMA tx channel 24, rx channel 25
 : SDHC controller (EDMA)
 sdhc0: SDHC 2.0, rev 49, platform DMA, 96000 kHz, HS 1.8V 3.0V, 1024 byte blocks
 sdmmc0 at sdhc0 slot 0
 sdhc1 at obio0 addr 0x481d8100-0x481d8fff intr 28sdhc1: EDMA tx channel 2, rx channel 3
 : SDHC controller (EDMA)
 sdhc1: SDHC 2.0, rev 49, platform DMA, 96000 kHz, HS 1.8V 3.0V, 1024 byte blocks
 sdmmc1 at sdhc1 slot 0
 tiiic0 at obio0 addr 0x44e0b000-0x44e0bfff intr 70: rev 0.11
 iic0 at tiiic0: I2C bus
 seeprom0 at iic0 addr 0x50: AT24Cxx or compatible EEPROM: size 32768
 tps65217pmic0 at iic0 addr 0x24: TPS65217C Power Management Multi-Channel IC (rev 1.2)
 tps65217pmic0: power sources USB max 1300 mA, [AC] max 2500 mA
 tps65217pmic0: [LDO1: 1800 mV] [LDO2: 3300 mV] [LDO3: 1800 mV] [LDO4: 3300 mV] [DCDC1: 1500 mV] [DCDC2: 1100 mV] [DCDC3: 1100 mV] 
 omapdmtimer0 at obio0 addr 0x48040000-0x48040fff intr 68: DMTIMER2
 omapdmtimer1 at obio0 addr 0x44e31000-0x44e31fff intr 67: DMTIMER1ms
 omapdmtimer2 at obio0 addr 0x48044000-0x48044fff intr 92: DMTIMER4
 omapwdt32k0 at obio0 addr 0x44e35000-0x44e35fff: rev 0.1
 tiotg0 at obio0 addr 0x47400000-0x47404fff intrbase 17: TI dual-port USB controller: version v1.0.0.13
 motg0 at tiotg0 port 0: 0x4ea20800 version v0.0.0
 motg1 at tiotg0 port 1: 0x4ea20800 version v0.0.0
 motg1: Dynamic FIFO sizing detected, assuming 16Kbytes of FIFO RAM
 usb0 at motg1: USB revision 2.0
 cpsw0 at obio0 addr 0x4a100000-0x4a107fff intrbase 40: TI CPSW Ethernet
 cpsw0: Ethernet address 90:59:af:5b:7d:8d
 ukphy0 at cpsw0 phy 0: OUI 0x00800f, model 0x000f, rev. 1
 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
 trng0 at obio0 addr 0x48310000-0x48311fff intr 111
 timecounter: Timecounter "clockinterrupt" frequency 100 Hz quality 0
 timecounter: Timecounter "dmtimer" frequency 24000000 Hz quality 100
 uhub0 at usb0: Mentor Graphics MOTG root hub, class 9/0, rev 1.00/1.00, addr 1
 uhub0: 1 port with 1 removable, self powered
 sdhc1: cmd timeout error
 WARNING: module error: can't find builtin dependency `nfsserver'
 ld1 at sdmmc1: <0xfe:0x014e:MMC02G:0x00:0x5581cc4e:0x000>
 ld1: 1832 MB, 930 cyl, 64 head, 63 sec, 512 bytes/sect x 3751936 sectors
 ld1: 4-bit width, 52.000 MHz
 ld0 at sdmmc0: <0x03:0x5344:SL08G:0x80:0x00755ab0:0x0f3>
 ld0: 7580 MB, 3850 cyl, 64 head, 63 sec, 512 bytes/sect x 15523840 sectors
 ld0: 4-bit width, High-Speed/SDR25, 50.000 MHz
 boot device: ld0
 root on ld0a dumps on ld0b
 mountroot: trying ext2fs...
 mountroot: trying ffs...
 root file system type: ffs
 WARNING: no TOD clock present
 WARNING: using filesystem time
 init: copying out path `/sbin/init' 11
                                 Michael van Elst
                                 "A potential Snark may lurk in every tree."

Home | Main Index | Thread Index | Old Index