it seems that configure scripts look for the xml-config program in
XML_CONFIG, not XML2_CONFIG. Can that be adjusted?


 - Hubert

Index: buildlink.mk
===================================================================
RCS file: /cvsroot/pkgsrc/textproc/libxml2/buildlink.mk,v
retrieving revision 1.6
diff -u -r1.6 buildlink.mk
--- buildlink.mk        2001/08/17 21:14:15     1.6
+++ buildlink.mk        2001/08/18 03:15:40
@@ -39,9 +39,9 @@
                ${BUILDLINK_DIR}/bin/xml2-config
 
 .if defined(USE_CONFIG_WRAPPER)
-XML2_CONFIG?=          ${BUILDLINK_CONFIG_WRAPPER.libxml2}
-CONFIGURE_ENV+=                XML2_CONFIG="${XML2_CONFIG}"
-MAKE_ENV+=             XML2_CONFIG="${XML2_CONFIG}"
+XML_CONFIG?=           ${BUILDLINK_CONFIG_WRAPPER.libxml2}
+CONFIGURE_ENV+=                XML_CONFIG="${XML_CONFIG}"
+MAKE_ENV+=             XML_CONFIG="${XML_CONFIG}"
 .endif
 
 pre-configure: ${BUILDLINK_TARGETS.libxml2}


-- 
Want to get a clue on IPv6 but don't know where to start? Try this:
* Basics -> http://www.onlamp.com/pub/a/onlamp/2001/05/24/ipv6_tutorial.html
* Setup  -> http://www.onlamp.com/pub/a/onlamp/2001/06/01/ipv6_tutorial.html 
Of course with your #1 IPv6 ready operating system -> http://www.NetBSD.org/