dennis@etinc.com (Dennis) writes:
> Is the new D-Link 4 port card supported under NetBSD?

Works just fine with "autoselect".  Using the mediaselect ifconfig
command to force 10/100 causes "ifconfig -a" to print that the device
isn't active (although it will work just fine.)

ppb1 at pci0 dev 14 function 0: Digital Equipment DECchip 21152 PCI-PCI Bridge (rev. 0x03)
pci2 at ppb1 bus 2
pci2: i/o enabled, memory enabled
de0 at pci2 dev 4 function 0
de0: interrupting at irq 10
de0: 21143 [10-100Mb/s] pass 4.1
de0: address 00:80:c8:f8:71:bc
de1 at pci2 dev 5 function 0
de1: interrupting at irq 15
de1: 21143 [10-100Mb/s] pass 4.1
de1: address 00:80:c8:f8:71:bd
de2 at pci2 dev 6 function 0
de2: interrupting at irq 9
de2: 21143 [10-100Mb/s] pass 4.1
de2: address 00:80:c8:f8:71:be
de3 at pci2 dev 7 function 0
de3: interrupting at irq 11
de3: 21143 [10-100Mb/s] pass 4.1
de3: address 00:80:c8:f8:71:bf

de0: flags=8963<UP,BROADCAST,NOTRAILERS,RUNNING,PROMISC,SIMPLEX,MULTICAST> mtu 1
500
        address: 00:80:c8:f8:71:bc
        media: Ethernet autoselect (10baseT)
        status: active
        inet 10.1.65.208 netmask 0xfffff000 broadcast 10.1.79.255
de1: flags=8863<UP,BROADCAST,NOTRAILERS,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        address: 00:80:c8:f8:71:bd
        media: Ethernet autoselect (100baseTX)
        status: active
        inet 10.174.88.1 netmask 0xffffff80 broadcast 10.174.88.127
de2: flags=8822<BROADCAST,NOTRAILERS,SIMPLEX,MULTICAST> mtu 1500
        address: 00:80:c8:f8:71:be
        media: Ethernet autoselect
de3: flags=8822<BROADCAST,NOTRAILERS,SIMPLEX,MULTICAST> mtu 1500
        address: 00:80:c8:f8:71:bf
        media: Ethernet autoselect

-wolfgang
-- 
       Wolfgang Rupprecht <wolfgang+gnus@dailyplanet.wsrcc.com>
		    http://www.wsrcc.com/wolfgang/
DGPS signals via the Internet  http://www.wsrcc.com/wolfgang/gps/dgps-ip.html