tech-kern archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index][Old Index]

Re: Adding KAUTH_DEVICE_TTY_ATTACH_<TYPE>



On Wed, May 06, 2009 at 03:55:28AM -0400, Thor Lancelot Simon wrote:
> On Wed, May 06, 2009 at 08:14:50AM +0100, Iain Hibbert wrote:
> > 
> > The other two I'm not sure about but in the future if somebody did the
> > work to switch strip(4) and slip(4) to auto-cloning devices, the ENABLE
> > for those could be dropped..
> 
> I think strip(4) should be removed.  Technically -- if the hardware it
> was written for still exists anywhere -- it would work, but only if
> someone had enough of the ancient radios to build a mesh network, since
> Metricom went boom and turned off all their repeaters a decade ago.

If somebody will send me a pair of strip(4) radios, I will maintain
the driver until either I run out of time, or strip(4) clearly holds
back kernel development, whichever comes first.

(What can I say, I like the idea of retro radio-networking.)

> I am not sure what should be done with slip(4).  It is possible that, by
> now, it should be removed too.

Speaking as one who has done a lot of rototillage of the network
drivers, especially by overhauling ifioctl(), both strip(4) and sl(4)
were painless to update compared with lmc(4), pdq(4), and srt(4).

Dave

-- 
David Young             OJC Technologies
dyoung%ojctech.com@localhost      Urbana, IL * (217) 278-3933


Home | Main Index | Thread Index | Old Index