On Aug 15,  7:31pm, haya@ilink.sony.co.jp (Hayakawa Koichi) wrote:
-- Subject: Re: CardBus on Libretto L2

| Can you change BIOS mode?  I'm not sure about Libretto 100,
| but maybe you can enter BIOS setting mode with pushing
| Escape key during power cycle time, then pressing F1 key.
| Maybe you can change PC CARD Controller Mode to
| CardBus/16-bit (it works with my Toshiba SS3010, which uses
| ToPIC97 CardBus bridge).  BIOS will route PCI INTR to
| CardBus bridge only under CardBus/16-bit mode.

Thanks, I have done this... And it still does not work. IIRC
my failure mode is the same as curts. I did not see any cards.

I'll try again.


christos