Hi

Ive been net-booting netbsd on several 3100/38 successfully for quite a
while, i just came to try it on a 4000/60, and while the boot process seems
to start ok, and the kernel appears to load (numbers + spinning |), after
this i cant see any output form the kernel booting, though the disks do
spin up.

Maybe this is because it doesnt support the gfx card and is instead
outputting to a serial line?  If so, which line would it use and (if any)
switches need set, as i tried plugging in a laptop + hyperterminal but
couldnt get any output.  Maybe 9600-8-n-1 is wrong?

Any suggestions welcome.  Im currently using 1.6.2.

Cheers


Adam
The information contained in this email may be commercially sensitive and/or legally privileged. It is intended solely for the person(s) to whom it is addressed. If you are not a named recipient, you are on notice of its status. Please notify the sender immediately by reply e-mail and then delete this message from your system. You must not disclose it to any other person, copy or distribute it or use it for any purpose.