Subject: Re: KFQSA problem
To: None <port-vax@netbsd.org>
From: M J Dowden <mjdowden@panix.com>
List: port-vax
Date: 06/04/2003 08:31:45
At 1:51 PM +0200 6/4/2003, Jochen Kunz wrote:

>[...] Do you want to boot from a SCSI
>drive or a drive on the KFQSA? Is there a TQK[57]0 in that box or
>comes the tape controller from the CMD SCSI controller?


     I was hoping to boot from a CD and use it to install NetBSD onto 
an RF72. I'd use the RF72 as the boot disk from that point on.


>Pull the KFQSA and CMD SCSI controller cards.
>Do "sh dev" and "sh q".
>Plug in the CMD SCSI controller and no other cards.
>Unconfigure all drives from it that are not pysically present.


     Would I do that from the console or from the MMJ jack on the CMD card?


>Do "sh dev" and "sh q".
>Plug in the KFQSA only and no other cards.
>Unconfigure all drives from it that are not pysically present.


     I assume that I'd do that by entering
>>>SET HOST/MAINTENANCE/UQSSP xxxxxxxx
and then "clearing" each item, correct?


>Do "sh dev" and "sh q".
>Then you can see what card uses what CSRs.
>If you want the CMD for primary controller leave it like it is,
>reconfigure the KFQSA and vice versa.


     Thanks very kindly. I'll get to work on this.

     Best regards,
     Mike Dowden

-- 
M J Dowden <mjdowden@panix.com>
PGP key: <http://www.panix.com/~mjdowden/keys.shtml>
No Microsoft products were used in the preparation or transmission of 
this message