> 	It is just a load card. The BA200 series boxes have two PSUs,
> 	one for each half of the Qbus slots. These are (IIRC) switched mode
> 	PSUs and they don't run unless there is a minimum load
> 	present. Usually the processor plus memory is
> 	enough to run the RH PSU and a KDA50 is enough
> 	for the LH PSU.

OK.  That would suggest that IFF the slots are being used by other
cards, I really don't need that in, and can free up one card slot,
if needed.  I need the last slot for one more card in the BA215 chassis.

Once I get everything tested out, and my BA213 cleaned up and repaired
it all will go back into the larger cabinet.  I will keep it in that
one, as a load, since I probably won't fill it out that far into the
left side of the bus.

Thanks

Bob