Brian ---
	***chuckle*** Yeah, I should've mentioned that that was the first
thing I checked. On mine, the button is recessed, so I would need a pen (or
such) to hit it.
	Also, when I started it up after the power down, I didn't put the
BNC Tee/resistor combo back on yet. It's back on now, and no change.
	In the ifconfig file, "AUI" (or "10Base-2" for the BNC) is the
correct entry for media type, right? It's not some other wierd thing, is it?

Thanks (in advance) again for your helping a VAX newt...

---   David A Woyciesjes
---   C & IS Support Specialist
---   Yale University Press
---   mailto:david.woyciesjes@yale.edu
---   (203) 432-0953
---   ICQ # - 905818


-> -----Original Message-----
-> From: Brian Chase [mailto:bdc@world.std.com]
-> Sent: Thursday, April 26, 2001 10:17 AM
-> To: David Woyciesjes
-> Cc: 'port-vax@netbsd.org'
-> Subject: Re: VAXstation 3100 M38 network problem....
-> 
-> 
-> On the VAXstation 3100s there's a little push button switch near the
-> ethernet controller.  It toggles the use of the AUI port and 
-> the 10Base-2
-> BNC connector.  Perhaps you accidentally bumped this and put 
-> the machine
-> in 10Base-2 mode instead of AUI mode?
-> 
-> -brian.
-> 
-> On Thu, 26 Apr 2001, David Woyciesjes wrote:
-> 
-> > 	Hello gents. I've subscribed to this list, but hasn't 
-> been approved
-> > yet (but that's a different problem)... So please send 
-> replies directly to
-> > me.
-> > 	I've loaded the release 1.5 on my VAX, via ftp. I have 
-> a CentreCOM
-> > 210TS media converter(transceiver) on my VAX's AUI port. 
-> Now, since I had to
-> > power it down to move it, I get this message at start up...
-> > "...
-> > Configuring network interfaces: le0ifconfig: SIOCSIFMEDIA: 
-> Device not
-> > configured
-> > ..." and 'ifconfig -a' reports the media as "Ethernet manual"
-> >
-> > I'm missing something, but I don't know what....
-> 
->