I've got NetBSD 1.5 running to the installation
prompt, but, the problem is that, it does not respond to
any key strokes!
	I've attached a VT420 console to the console
port, is there any special configuration on the terminal
to make it work? or it should just do the job?
	I'm booting from an Slackware 7.1 box with
NetBSD 1.5, and I think that the boot process goes fine
but it just stops responding and I can't figure out if
it has hanged or what?!?

	I'm a little bit familiar with Unixish systems
but I dunno much about these VAX boxes.

Can anyone help me?