> NetBSD Bob wrote:
> Anyone have a spare copy or xerox of a dilogic controller manual?
> 
	>OK, now we are getting to the nittygritty.  What are the switch
settings
	>to use a TK50 as a secondary controller?

	The secondary address is floating in the range 17760010-17763776
	(octal). Exactly what you pick depends on what else you have in
there.
	Almost any Q-bus box later than a MicroVAX II has a CONFIG command
	built in to the console which lets you work this out.

	The address bits are set with A12:A2 (A2 is the jumper nearest
	the edge). Leave the switch packs alone.

	If you post exactly which cards you expect to have in your box
	I can run them through SYSGEN  CONFIG on VMS for you.

	>OK, I have heard of this infamous tape, and I thought I had one in
my
	>tape collection, but I can't seem to find it.  

	You sure it's not just that the margin is too small for you
	to write in it :-)

	Antonio