At 12:27 PM 9/18/2000 -0400, NetBSD Bob wrote:
>I picked up a whole 1 dollar VT-320 terminal that was one of the ones
>that originally went with the MicroVAX 3300 I now have.  The terminal
>seems to come up and selftest OK, but I can't get it to accept any
>sort of prom commands to rest the baud rate from what appears to be
>1200 baud to the default 9600 baud in the comm section.  I can get
>either a LK201 or LK401 keyboard to push the cursor to the comm
>section, but it does not accept anything after that point except
>an move to exit, or continued cursor movement to other sections of
>the prom.  It almost appears as if the monitor is locked up in some
>way.  Anyone know anything in a VT-320 prom that would disallow
>setting prom commands such as baud rate?

Use the setup key (aka F3) to enter the setup window.
--
Matt Thomas               Internet:   matt@3am-software.com
3am Software Foundry      WWW URL:    http://www.3am-software.com/bio/matt/
Cupertino, CA             Disclaimer: I avow all knowledge of this message