On the 3300, even though the KFQSA is the "second" disk controller, it is 
controller 0 on the MSCP bus. Thus the command should be:
>         set host/maintenence/uqssp/mscp 0
Rather than 1. If I can get a KFQSA into my 3400 I'll see if I can make it 
talk correctly.

--Chuck


At 07:07 AM 9/12/00 -0400, Kevin Ogden wrote:
>Hi...  I'm trying to add another drive to my MicroVAX 3300 w/ KFQSA.  I 
>followed
>the instructions in a message in the archive to go about reprogramming the 
>KFQSA
>to talk to more drives.  Everything goes well until I tried the command:
>
>set host/maintenence/uqssp/mscp 1
>
>the KA640 then replies with UNK SW.  I tried this with the KFQSA in both 
>program
>and run modes with no success.  Is this command not supported on the KA640?
>  Is there an equivelant command?
>
>When I reboot, the machine still only sees the drive I had in there before,
>it doesn't see the second drive I added.
>
>Any help would be greatly appreciated.
>
>--Kevin