The baud rate listed in the serial port documentation on CMDs
website is wrong. IIRC they say 9600, but it should be 19200.
Contact me OL if this doesn't help, and I will try to walk
you through it. I have a CQD-2?0TM here, and I have talked to
it through the 10 pin connector.

clint
vaxman@uswest.net


On Thu, 3 Aug 2000, Frederik Meerwaldt wrote:

> Hi!
> 
> As we are already speaking about SCSI-Controllers, I have a little
> question here, too.
> I have a CQD-220TM SCSI Controller, and I would really like to use it with
> my MicroVAX II.
> But it seems that you have to configure this controller, as I have
> downloaded the Documentation from www.cmd.com and the small port at the
> side is a serial port. Well, I hooked up a VT220, but I don't get anything
> on this port. And AFAIK I have build the cable correctly.
> I don't know whether it is working or not, but AFAIK it came out of an
> working MVII.
> So my Question: Does it work with NetBSD? Can I boot from it? Do I need
> extra Configuration?
>  
> Thanks in advance
> -- 
> Best Regards,
> 	Freddy
> 
> =====================================================================
> Frederik Meerwaldt  ICQ: 83045387  Homepage: http://www.freddym.org
>  Bavaria/Germany              OpenVMS and Unix Howtos and much more
>    FREEBSD, NETBSD, OPENBSD, TRU64, OPENVMS, ULTRIX, BEOS, LINUX
> 
> 
> 
>