Hello, I have a MicroVAX 3100-80, which is listed as "probably will not
work" on the VAX info page.  
I got the machine to netboot using the 20000517 snapshot.  The machine
appears to run fine until input from the console is needed, then I can't
do anything.  No input is accepted at all. I am using a VT320 connected to
the terminal MMJ on the back.

The dmesg (as much as I could get from the screen) is:

VAXstation 4000/60
cpu: KA46
cpu: turning on floating point chip
total memory = 40696 KB
avail memory = 34628 KB
using 534 b<backwards question mark>vsbus0: interrupt mask 0
le0: address 08:00:2b:2c:d6:61
le0: 32 recieve buffers, 8 transmit buffers
dz0 at vsbus0 csr 0x200a0000 vec 124 ipl 15 maskbit 4
dz0: 4 lines
ncr intr = 128
asc0 at vsbus0 csr 0x200c0080 vec 124 ipl 15 maskbit 0
asc0: NCR53C94, 25MHz, SCSI ID 6
scsibus0 at asc0: 8 targets, 8 luns per target
scsibus0: waiting 2 seconds for devices to settle...
probe(asc0:1:0): max sync rate 4.80MB/s
sd0 at scsibus0 target 1 lun 0: <CDC, 94191-15, 0136> SCSI1 0/direct fixed
sd0: 632 MB, 1632 cyl, 15 head, 52 sec, 512 bytes/sect x 1295850 sectors

show config output:

KA47-A V1.4-38D-V4.2
08-00-2B-2C-D6-61
40MB

DEVNBR    DEVNAM           INFO
-----     --------    -------------------------
    1          NVR    OK
    3           DZ    OK
    4        CACHE    OK
    5          MEM    OK
                      40MB= S0/1=8MB, S2/3=32MB, S4/5=0MB
    6          FPU    OK
    7           IT    OK
    8          SYS    OK
    9           NI    OK
   10         SCSI    OK
                      1-LO-94191-1 6-INITR


I would like to get NetBSD running on this machine, as otherwise the
machine is nothing more than a paperweight. =)

Thanks,

Sean Cavanaugh
seanc@cginfo.sk.ca
http://www.cginfo.sk.ca