Note that unless this drive was "formatted" using the RQDX3 controller I 
don't think it will recognize it. If you have the XXDP code handy you could 
do it, or if you have a later vax like a KA655 then the formmater is in 
firmware. I've forgotten/lost which CPU you are using, so I can't advise 
further.
--Chuck


At 10:12 PM 1/7/00 +0100, Screenager.2000@gmx.net wrote:
>Hi,
>I'm still having trouble mounting my Maxtor XT2190 drive. The kernel tells
>me the device is offline. The ready botton on the console doesn't response
>and the LED isn't on. I'm not sure if the HD cable is assigned to pin nr. 1
>and I don't have any possibility to check on that because there is no way to
>find the information in the RQDX3 users manual.
>Any suggestions ?
>Thanks
>                   Chris
>
>--
>Sent through Global Message Exchange - http://www.gmx.net