I have just attempted to install 1.4.1 on a microvax II with 16 megs RAM,
and a 120 meg ESDI hard disk on a qd21. I am using the boot.fs image from a
floppy disk. (I pluged a 1.44 meg drive in and it thinks its a RX33,I
created the image by setting the type to 1.2 in the bios on a pc) The
installation aborts after choosing a custom installation. (also does it if I
choose standard or standard with x) with the message

/:write failed, file system is full
Floating point exception
#
                            uid 0 on /: file system full


at which point I am left at a # prompt