from the strong show of people who replied ot me by mail asking for some
UC0[78] info, heres some basics that i think most folks were after:

jumper /DIP settings:

SW3 and/or 4:

CSR	SW3/4 1 2 3 4
72150		0 0 0 0 
72154	1 0 0 0
60334	0 1 0 0
60340	1 1 0 0
60344	0 0 1 0
60350	1 0 1 0
 and so on down to 
60420	1 1 1 1

SW1/2
1	off- run on- reset/halt
2	off- enable  on- disable
3 reserved
4	off-normal on-loop self test

SW3/4
5	off-TMSCP on-MSCP
6	(mscp only) off-disable autoboot on-enable autoboot

interrupt request level (default is 4 and the manual highly recommends it)
quad wide uco7/8        4       5
scsi bus 1 - jumper PR	in	out
                    RS	out	in

bus 2-		    LM 
		    MN same as above

on a dual-wide UC07, same story, but theyre jumpers TU and UV


on a microVAX, heres how to start the firmware for disks. 

first, a handy table

csr	XXXX	YYYY
72150	1468	146a
72154	146c	146e
60334	00dc	00de
60340	00e0	00e2
60344	00e4	00e6

and so on down to
60420	0110	0112


now at the chevron, enter
i
d/p/w 20001f40 20
d/p/l 20088000 80000000
d/p/l 20088004 80000001
d/p/w 2000XXXX 1
d/p/w 2000YYYY 3003
d/p/w 2000YYYY 4401
pause a second
then
s 80
if that fails, wait a second or two then try s 80 again.
the firmware is menu driven and conversational, very easy to use. 

if anyone still wants a xerox of the manual after this info, 
lemme know