Wow, that's pretty mucked up.  What's the system you're using as your
bootserver?  What does "show ether" report from the ">>>" prompt?

-brian.

On Sat, 27 Feb 1999, Dean Bennett wrote:

> I'm trying to net boot a VAXstation 3100/M38, but it seems that I'm
> getting a bit changed somewhere.  Note in the debug output from mopd
> below that the hardware address is changed from 8:0:2b:14:9b:c3 to
> 8:0:2b:14:9b:c1 and the load file gets changed from MOPBOOT to MOPBMOT.
> 
> Any ideas as to what might be going on (the vax seems to work fine with
> VMS and DECnet).  I've been following the netbooting howto, but I can't
> get past this point.
> 
> 
> Dst          : ab:0:0:1:0:0      MOP Dump/Load Multicast
> Src          : 8:0:2b:14:9b:c1
> Proto        : 6001 MOP Dump/Load
> Length       : 002e (46)
> Code         :   08 Request program
> Device Type  :   25 LQA 'DELQA'
> Format       :   01
> Program Type :   00 Secondary Loader
> Software     :   07 'MOPBMOT'
> Processor    :   00 System Processor
> Maint Version: 4.0.0
> 
> Dst          : 8:0:2b:14:9b:c1
> Src          : 0:10:4b:1e:a5:ff
> Proto        : 6001 MOP Dump/Load
> Length       : 0001 (1)
> Code         :   03 Assistance volunteer
> 

---
Brian "JARAI" Chase | http://world.std.com/~bdc/ | VAXZilla LIVES!!!