Paul wrote:
> 
> >>> show dev
>  VMS/VMB  ULTRIX    ADDR    DEVTYP  NUMBYTES  RM/FX  WP  DEVNAM  REV
>  -------  ------  --------  ------  --------  -----  --  ------  ---
>  ESA0     SE0     08-00-2B-13-AE-3E
> 
>  DKA0     RZ0     A/0/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKA100   RZ1     A/1/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKA200   RZ2     A/2/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKA300   RZ3     A/3/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKA400   RZ4     A/4/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKA500   RZ5     A/5/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKA600   RZ6     A/6/0/00  DISK      104 MB   FX        RZ23   0A18
>  ...HostID....    A/7       INITR
> 
>  DKB0     RZ8     B/0/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKB100   RZ9     B/1/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKB200   RZ10    B/2/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKB300   RZ11    B/3/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKB400   RZ12    B/4/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKB500   RZ13    B/5/0/00  DISK      104 MB   FX        RZ23   0A18
>  DKB600   RZ14    B/6/0/00  DISK      104 MB   FX        RZ23   0A18
>  ...HostID....    B/7       INITR

>From this display it looks like your SCSI controllers are set to SCSI ID
7. Good.

I'd hazard a guess that the disks are also set to SCSI ID 7 (i.e. all
three SCSI ID jumpers are in place).

I seem to remember that the placement of the SCSI ID jumpers on the RZ23
is not immediately obvious. Anyone have a diagram or manual which could
confirm where the SCSI ID jumpers are on an RZ23?

Gunnar

--
Gunnar Helliesen   | Bergen IT Consult AS  | NetBSD/VAX on a uVAX II
Systems Consultant | Bergen, Norway        | '86 Jaguar Sovereign 4.2
gunnar@bitcon.no   | http://www.bitcon.no/ | '73 Mercedes 280 (240D)