> > Can anyone provide me with configuring (switch settings, etc) information 
> > about the DHQ-11 8-line async mux (M3107) and the board connector ->
> > bulkhead connector pinout of the DHV-11 (M7940) [so the original DHV11,
> > not the DLV11-J, DLV1J]?
> 
> DHV-11... seesh... I was meant to say "DLV-11"... I'm looking for the
> pinout of the connector on that board... But real desperately...

The 40-pin serial connector on the "original" DLV11 (as opposed to
later ones using the 10-pin connector, like the DLV11J) is the same
as on the Unibus DL11-W.  All of these are well documented in the
archive available at:

ftp://sunsite.unc.edu/pub/academic/computer-science/history/pdp-11/hardware/

The DL11-W pinout is detailed in "dl11-w.info2", and the DLV11-J is
documented in DLVJ1.info.

-- 
 Tim Shoppa                        Email: shoppa@trailing-edge.com
 Trailing Edge Technology          WWW:   http://www.trailing-edge.com/
 7328 Bradley Blvd                 Voice: 301-767-5917
 Bethesda, MD, USA 20817           Fax:   301-767-5927