Bob Harbour wrote:
> 
> Hi
> I am putting a Sigma MSCP/TMSCP SCSI controller into my 
> microvax III box,
> and need the CSR addresses and interrupt levels for the 
> second MSCP and
> TMSCP controllers. I currently have an RQDX3 and TK50 at 
> 172150 and 174500
> repectively. 


$ mc sysgen
SYSGEN>  CONFIGURE
DEVICE> uda,2
DEVICE> tu81,2
DEVICE>  Exit 
Device: UDA   Name: PUA   CSR: 772150   Vector: 154   Support: yes 
Device: TU81  Name: PTA   CSR: 774500   Vector: 260   Support: yes 
Device: UDA   Name: PUB   CSR: 760334*  Vector: 300*  Support: yes 
Device: TU81  Name: PTB   CSR: 760444*  Vector: 304*  Support: yes 
SYSGEN>  


Sometimes having a VMS system around can be handy. ;-)

On some (most? all?) uVAX IIIs you can also enter the configure command
at the >>> prompt. Same syntax as above.

> Also I was wondering if the generic 1.3 kernel 
> is configured
> for the extra controllers?


# Disk controllers at Unibus
uda0            at uba? csr 0172150     # UDA50/RQDX?
uda1            at uba? csr 0160334
mscpbus*        at uda?  

# Tape drivers  
mtc0            at uba? csr 0174500     # Tape MSCP ctlr
mscpbus*        at mtc?


So the answer is yes for the extra disk controller and no for the extra
tape controller.

Gunnar

--
Gunnar Helliesen   | Bergen IT Consult AS  | NetBSD/VAX on a uVAX II
Systems Consultant | Bergen, Norway        | '86 Jaguar Sovereign 4.2
gunnar@bitcon.no   | http://www.bitcon.no/ | '73 Mercedes 280 (240D)