> After howto=...
> it falls in HLT instruction...
> What's hell?
> Please, help me, if anybody already passed through this trouble....

Same here.. I SUPped the -current and after a 'make build' (a few days 
later :-) I got a broken /boot. It loads, prints a (new) banner with 
NetBSD/VAX bootstrap blah blah.

Then it prints the :/netbsd and dies with a HALT.
System is an uVAX 3600 with 32 Mb RAM and UC07 SCSI controller/disk

I restored the /boot from my install tape so all is OK again..

Did the boot-block itself change as well? I'll try an installboot 
as well just to be sure.. 

							Bye Arno.

-- 
Internet Exchange Europe B.V.Fax: +31-70-3630470 | One disk to rule them all,
Lange Voorhout 9  	     Tel: +31-70-3600379 | One disk to bind them,
2514EA Den Haag +--------------------------------+ One disk to hold the files
The Netherlands |   * END OF TRANSMISSION *      | And in the darkness grind 'em