-----BEGIN PGP SIGNED MESSAGE-----


O.K...

Have a MicroVAX-II, SCSI Controller with SCSI hard disks and 8mm tape drive,
TK50 tape drive and KDA50 controller for some RA81 hard disks.

Now, I need to one figure out what address my DELQA ethernet card is set to 
so I can see if I need to change it because when I stick it in the system, 
it won't boot.  If I remove KDA50 controller (which is set up as the 
secondary hard disk and works under VAX/VMS) everything boots.

So, how to I determine what address this thing is set to and how do I 
change it if I have to..

Thanks in advance.


 +------------------------+--------------------------------------------+
 | Robert Alan Byer       | A-Com Computing, Inc.                      |        
 | Vice-President         | 115 W. Washington Street, Suite 1165       |
 | A-Com Computing, Inc.  | Indianapolis, IN 46204                     |
 | Phone: (317)673-4204   | http://www.all-net.net/                    | 
 +------------------------+-----+--------------------------------------+
 | byer@mail.all-net.net        | I don't want to take over the world, |
 | http://www.all-net.net/~byer | just my own little part of it.       |
 +------------------------------+--------------------------------------+
 | Send an E-mail request to obtain my PGP key.                        |
 +---------------------------------------------------------------------+

-----BEGIN PGP SIGNATURE-----
Version: 2.6.2

iQEVAwUBM/p2GaVSqzlBVJbBAQEKCQf/StTMI8+qWSVaqKgBoPNoFLlmXDxEDxU9
9U+qr0VsuajLnFDLG7GRDe+U4UyqOm/Cb9TQhPTOOnvrNRRNJyDdfg6OSb8PG/iN
YhbzCVMwZ3d8jc25PG8UfvjY6pkTtTolD3It1DeweO66Aq6FKrg5ROy1MgjgiHWt
lllYiYsDms1eTLNzxXKFNyAtNP+nxM2/AExo2DNaNXawP9XBE5TLk0HWVu9CLbn8
RlTqpRvJ7tclF74C/Pf4VYunUr47G3HRsMPe/D4iyOLpYkeT8iRNEY9Xs/YxCOUB
xcXqWuUW1QTA/eeToOZDR7EzW2VpAYpsO+tYsQbZyZMkS/jwPrZGjA==
=EqpA
-----END PGP SIGNATURE-----