Hi Gang:

I am working on the TS11 driver for 1.1A.

When I increase the size of my kernel by adding debug/trace code I
invariably get dumped into the debugger with a "trap 2 code 0 PSL 8"
reg dump. 

I suspect an increase in kernel size as I also got this message a
couple of weeks ago when I added another couple of entries to the
config file for my machine. The new entries were for disk
controllers, not related to the tape driver. The only commonality was
that in both cases the kernel size increased, this appears to be what
is causing the dump.

I have 13 MB on the machine, avail memory is 10556416, it says "using
655 buffers containing 680960 bytes of memory", if this is relevant.

What can I do to allow the new code to be successfully added to the
kernel???

Kevin

-- 
Kevin McQuiggin VE7ZD
mcquiggi@sfu.ca