On Sun, 28 Apr 1996, Todd Mailandt wrote:

> Thomas,
>         Thanks so much for the connection info.  Unfortunately, I still
> can't connect -- not that there were any problems with your instructions --
> I may have a hardware problem.  Speaking of the diagnostic codes, you
> wouldn't happen to have a manual handy, would you?  When I first turn on the
> machine, the floppy drive bumps for about a half second, and then nothing
> else happens.  The diagnostic lights flash around for about 30 seconds, and
> finally come to rest with nos. 1 and 7 lighted.  The hard drive doesn't spin
> up at all.  Any ideas?  Thanks.
> 

Well if you are counting from right to left this would indicate that the 
system failed the test of the NI (ethernet).  If the system is not 
connected to a network, try placing a terminator on whichever ethernet 
interface you've selected.  (ie. Thin or Thick)  Once this is done try 
powering it up again. If you get the same light indications, you most 
likely have a bad NI.

The hard drive will not spin up until it is accessed.  

>   
>  
>            ______________________________     
>           |____   _____________   _____  |    Todd M. Mailandt    
>                | |  _____   ___| |  ___| |    5379 Eastway, Apt. 2
>                | | |  _  | |  _  | |  _  |    Greendale, WI 53129
>                | | | | | | | | | | | | | |    (414) 423-1740
>                | | | |_| | | |_| | | |_| |    Internet E-mail:
>                |_| |_____| |_____| |_____|    tmailand@execpc.com
> 
> 
> 
> 

--
Thomas Traylor
Thomas.Traylor@mci.com
tst@titan.cs.mci.com
(719) 535-1269