Re: Ultra10 problems with -current

[Sad Clouds <cryintothebluesky%googlemail.com@localhost>]

On Tue, 1 Nov 2011 19:02:56 +0100
Martin Husemann <martin%duskware.de@localhost> wrote:

> FWIW: with serial console and -current my U5 says:
> 
> machfb0 at pci1 dev 2 function 0: vendor 0x1002 product 0x4754 (rev.
> 0x9a) machfb0: 16 MB aperture at 0xe1000000, 4 KB registers at
> 0x00000000 machfb0: 2048 KB SGRAM 62.999 MHz, maximum RAMDAC clock
> 170 MHz mach64_get_mode: 1152 5304 5432 1528 900 902 938 937
> machfb0: initial resolution 1152x864 at 8 bpp
> machfb0: attached to /dev/fb0
> machfb0: initializing the DSP
> wsdisplay1 at machfb0
> cmdide0 at pci1 dev 3 function 0
> ...
> 
> and boots just fine.
> 
> Maybe it needs a display with edid attached to cause problems? But
> your descriptions sounds like you are using the machfb as console?
> 
> Martin

Well to sum it up, there are two issues:

1. 
I have Creator3D as the console, but kernel hangs with the last line
printed - 'machfb0: initializing the DSP'

2.
Commenting out machfb from kernel config and when at OpenBoot I have
'setenv output-device screen:r1600x1200x75' then booting from install
CD causes the screen go blank. When I reset it to 'setenv output-device
screen' then install CD boots OK and I can see sysinstall on blue
background.

Anybody else having problems when initial resolution set to
1600x1200x75?