Free Ultra5 in Silicon Valley, USA

[Steve Rikli <sr%genyosha.net@localhost>]

I've got an Ultra5 to make available to the project.

Short config:  Ultra5 1x333MHz, 512MB RAM, 20GB disk, DVD-ROM
   add-on PCI HME card

Full 'dmesg' is attached.

The hardware is stable but the case is a little sun-faded (no pun
intended).  I adopted it from a friend who wasn't using it anymore.
He replaced the stock Sun CDROM with an IDE DVD-ROM drive, as noted.

I installed NetBSD3.1 on it to clean the disk and verify the hardware.

NOTE:  I may have some Ultra5 CPU and memory upgrades to give away
in the near future, so if you'd like to upgrade this Ultra5 with a
faster CPU keep an eye open.

The Ultra5 is located in Sunnyvale, California, USA.  I estimate it
would cost around US$25 to ship it inside the USA, but I only ask for
exact shipping in return -- if it's less, so much the better ;-) and
local pickups are also welcome.

Please give this nice ole box a good NetBSD home!

Cheers,
sr.

ok banner
Sun Ultra 5/10 UPA/PCI (UltraSPARC-IIi 333MHz), No Keyboard
OpenBoot 3.31, 512 MB (60 ns) memory installed, Serial #10934813.
Ethernet address 8:0:20:a6:da:1d, Host ID: 80a6da1d.

--

console is /pci@1f,0/pci@1,1/ebus@1/se@14,400000:a
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 3.1 (GENERIC) #0: Tue Oct 31 09:36:38 UTC 2006
        
builds%b0.netbsd.org@localhost:/home/builds/ab/netbsd-3-1-RELEASE/sparc64/200610302053Z-obj/home/builds/ab/netbsd-3-1-RELEASE/src/sys/arch/sparc64/compile/GENERIC
total memory = 512 MB
avail memory = 489 MB
bootpath: /pci@1f,0/pci@1,1/ide@3,0/disk@0,0
mainbus0 (root): SUNW,Ultra-5_10: hostid 80a6da1d
cpu0 at mainbus0: SUNW,UltraSPARC-IIi @ 333 MHz, version 0 FPU
cpu0: 32K instruction (32 b/l), 16K data (32 b/l), 2048K external (64 b/l)
psycho0 at mainbus0 addr 0xfffc4000
SUNW,sabre: impl 0, version 0: ign 7c0 bus range 0 to 2; PCI bus 0
DVMA map: c0000000 to e0000000
IOTSB: 862000 to 8e2000
pci0 at psycho0
pci0: i/o space, memory space enabled
ppb0 at pci0 dev 1 function 1: Sun Microsystems Simba PCI bridge (rev. 0x13)
pci1 at ppb0 bus 1
pci1: i/o space, memory space enabled
ebus0 at pci1 dev 1 function 0
ebus0: Sun Microsystems PCIO Ebus2, revision 0x01
auxio0 at ebus0 addr 726000-726003, 728000-728003, 72a000-72a003, 
72c000-72c003, 72f000-72f003
power at ebus0 addr 724000-724003 ipl 37 not configured
SUNW,pll at ebus0 addr 504000-504002 not configured
sab0 at ebus0 addr 400000-40007f ipl 43: rev 3.2
sabtty0 at sab0 port 0: console i/o
sabtty1 at sab0 port 1
com0 at ebus0 addr 3083f8-3083ff ipl 41: ns16550a, working fifo
kbd0 at com0
com1 at ebus0 addr 3062f8-3062ff ipl 42: ns16550a, working fifo
ms0 at com1
wsmouse0 at ms0 mux 0
lpt0 at ebus0 addr 3043bc-3043cb, 30015c-30015d, 700000-70000f ipl 34
fdthree at ebus0 addr 3023f0-3023f7, 706000-70600f, 720000-720003 ipl 39 not 
configured
clock0 at ebus0 addr 0-1fff: mk48t59
flashprom at ebus0 addr 0-fffff not configured
audiocs0 at ebus0 addr 200000-2000ff, 702000-70200f, 704000-70400f, 
722000-722003 ipl 35 ipl 36: CS4231A
audio0 at audiocs0: full duplex
hme0 at pci1 dev 1 function 1: Sun Happy Meal Ethernet, rev. 1
hme0: interrupting at ivec 3021
hme0: Ethernet address 08:00:20:a6:da:1d
nsphy0 at hme0 phy 1: DP83840 10/100 media interface, rev. 1
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
machfb0 at pci1 dev 2 function 0: ATI Technologies 3D Rage Pro (rev. 0x5c)
machfb0: 16 MB aperture at 0xe1000000, 4 KB registers at 0xe2000000
memctl: 00651a77
machfb0: 4096 KB SGRAM 98.924 MHz, maximum RAMDAC clock 230 MHz
machfb0: initial resolution 1152x864 at 8 bpp
initializing the DSP
wsdisplay1 at machfb0 kbdmux 1
wsmux1: connecting to wsdisplay1
wsdisplay1: screen 0-3 added (default, sun emulation)
cmdide0 at pci1 dev 3 function 0
cmdide0: CMD Technology PCI0646 (rev. 0x03)
cmdide0: bus-master DMA support present
cmdide0: primary channel configured to native-PCI mode
cmdide0: using ivec 1820 for native-PCI interrupt
atabus0 at cmdide0 channel 0
cmdide0: secondary channel configured to native-PCI mode
atabus1 at cmdide0 channel 1
ppb1 at pci0 dev 1 function 0: Sun Microsystems Simba PCI bridge (rev. 0x13)
pci2 at ppb1 bus 2
pci2: i/o space, memory space enabled
Sun Microsystems PCIO Ebus2 (miscellaneous bridge, revision 0x01) at pci2 dev 1 
function 0 not configured
hme1 at pci2 dev 1 function 1: Sun Happy Meal Ethernet, rev. 1
hme1: interrupting at ivec 3011
hme1: Ethernet address 08:00:20:a6:da:1d
ukphy0 at hme1 phy 1: Generic IEEE 802.3u media interface
ukphy0: OUI 0x0006b8, model 0x000c, rev. 1
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
pcons at mainbus0 not configured
No counter-timer -- using %tick at 333MHz as system clock.
wskbd0 at kbd0 mux 1
kbd0: reset failed
wskbd0: connecting to wsdisplay1
Kernelized RAIDframe activated
wd0 at atabus0 drive 0: <ST320420A>
wd0: drive supports 16-sector PIO transfers, LBA addressing
wd0: 19458 MB, 39535 cyl, 16 head, 63 sec, 512 bytes/sect x 39851760 sectors
wd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 4 (Ultra/66)
wd0(cmdide0:0:0): using PIO mode 4, DMA mode 2 (using DMA)
atapibus0 at atabus1: 2 targets
cd0 at atapibus0 drive 0: <_NEC DVD_RW ND-3550A, , 1.05> cdrom removable
cd0: drive supports PIO mode 4, DMA mode 2, Ultra-DMA mode 2 (Ultra/33)
cd0(cmdide0:1:0): using PIO mode 4, DMA mode 2 (using DMA)
root on wd0a dumps on wd0b
root file system type: ffs