Subject: RAIDframe
To: NetBSD/Sparc64 Discussion List <port-sparc64@NetBSD.ORG>
From: Eric Fox <>
List: port-sparc64
Date: 08/07/2003 12:57:50
I've installed NetBSD/Sparc64 on a Sun v100.  It appears to run fine,
except that when it boots, I get the following message:

  Kernelized RAIDframe activated
  root device:

This machine only has ONE disk and it won't finish booting up until I
tell it "wd0a".

I've been through the man pages, but they describe how to configure and
setup a raid array.  I don't see anything on how to completely disable
RAIDframe.  Is there away to do this so I don't have to respond to this
prompt at every boot?

  /\---/\  Eric J Fox
 /  o o  \
 \.\   /./ ---------------------------
    \@/    "Of course it runs NetBSD."