Subject: Ultra1 200MHz Install
To: None <port-sparc64@netbsd.org>
From: None <bgreen@greenmachineworks.com>
List: port-sparc64
Date: 07/12/2001 12:26:16
I am trying to install NetBSD 1.5 on an Ultra 1 200MHz (iso image cdrom) and get an output that is similar to a problem described by a person on the list trying to load a Netra T1 AC200 (see message below this one). I get similar results with a SunBlade 100 I have. I am a bit surprized as I thought this version had been tested on Ultra1 200Mhz hardware? Am I missing something ??

Looking at the output I don't see the kernel picking up the hard drive. Know its there cause Solaris fires up on this machine just fine. Output I am getting on install...

ok boot cdrom
Boot device: /sbus/SUNW,fas@e,8800000/sd@6,0:f  File and args:
NetBSD IEEE 1275 Bootblock
..>> NetBSD/sparc64 OpenFirmware Boot, Revision
>> (eeh@nonplus.one-o.com, Fri Nov 17 08:22:25 PST 2000)
loadfile: reading header
elf64_exec: Booting /sbus@1f,0/SUNW,fas@e,8800000/sd@6,0:f/netbsd
3028754@0x1000000+219984@0x1400000+433440@0x1435b50
symbols @ 0xffefc300 74+242976+125598 start=0x1000000
chain: calling OF_chain(800000, ee00, 1000000, fffb3a80, 18)
[ preserving 369424 bytes of netbsd ELF symbol table ]
consinit()
setting up stdin
stdin instance = fffe8518
setting up stdout
stdout instance = fffe8708
stdout package = f005a88c
console is unknown
Copyright (c) 1996, 1997, 1998, 1999, 2000
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.5 (GENERIC) #14: Wed Nov 22 10:44:31 PST 2000
    eeh@nonplus.one-o.com:/home5/src/src/sys/arch/sparc64/compile/GENERIC
total memory = 128 MB
avail memory = 109 MB
using 832 buffers containing 6656 KB of memory
bootpath: /sbus@1f,0/SUNW,fas@e,8800000/sd@6,0:f
mainbus0 (root): SUNW,Ultra-1
cpu0 at mainbus0: SUNW,UltraSPARC @ 200 MHz, version 0 FPU
cpu0: physical 4K instruction (32 b/l), 4K data (32 b/l), 2048K external (64 b/l
)
timer0 at mainbus0 addr 0xfffc3c00 irq vectors 7f0 and 7f1
sbus0 at mainbus0 addr 0xfffcc000: clock = 25 MHz
DVMA map: ff802000 to ffffe000
audiocs0 at sbus0 slot 13 offset 0xc000000 vector 24 ipl 13: CS4231A
audio0 at audiocs0: full duplex
auxio0 at sbus0 slot 15 offset 0x1900000
flashprom at sbus0 slot 15 offset 0x0 not configured
SUNW,fdtwo at sbus0 slot 15 offset 0x1400000 vector 29 ipl 11 not configured
clock0 at sbus0 slot 15 offset 0x1200000: mk48t59 (eeprom) hostid ffffffff8085ec
39
zs0 at sbus0 slot 15 offset 0x1100000 vector 28 ipl 12 softpri 6
zstty0 at zs0 channel 0 (console i/o).W at zs0 channel 1
zs1 at sbus0 slot 15 offset 0x1000000 vector 28 ipl 12 softpri 6
kbd0 at zs1 channel 0
ms0 at zs1 channel 1
intr_establish: intr reused 2024
sc at sbus0 slot 15 offset 0x1300000 not configured
SUNW,pll at sbus0 slot 15 offset 0x1304000 not configured
SUNW,fas at sbus0 slot 14 offset 0x8800000 vector 20 ipl 3 not configured
hme1 at sbus0 slot 14 offset 0x8c00000 vector 21 ipl 6: address 08:00:20:85:ec:3
9
nsphy0 at hme1 phy 1: DP83840 10/100 media interface, rev. 0
nsphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
bpp0 at sbus0 slot 14 offset 0xc800000 vector 22 ipl 2: rev unknown (0x20000000)
cgsix0 at sbus0 slot 1 offset 0x0 vector 5 ipl 5: SUNW,501-2325, 1152 x 900, rev
 11
pcons at mainbus0 not configured
raidattach: Asked for 4 units
Kernelized RAIDframe activated
root device:

Bryan Green
Green Machine Works
bgreen@greenmachineworks.com

++++++++++++++++++++++++++++++++++++++++++++++++++++

Subject: Netra T1 AC200
To: None <port-sparc64@netbsd.org>
From: Aleksey V Fedorov <alexf@vsi.ru>
List: port-sparc64
Date: 06/01/2001 09:50:26 
  I am try to run NetBSD on Netra T1 AC200, and has the folowing output.
What's wrong? 



Netra T1 200 (UltraSPARC-IIe 500MHz), No Keyboard
OpenBoot 4.0, 256 MB memory installed, Serial #16098704.
Ethernet address 8:0:20:f5:a5:90, Host ID: 80f5a590.



Executing last command: boot net                                      
Boot device: /pci@1f,0/pci@1,1/network@c,1  File and args: 
15400 >> NetBSD/sparc64 OpenFirmware Boot, Revision 
>> (martin@setting-sun.duskware.de, Fri May 18 08:09:34 CEST 2001)
Using BOOTPARAMS protocol: ip address: 192.168.0.1, hostname: netra
root addr=192.168.0.2 path=/vms/nfs_root
loadfile: reading header
elf64_exec: Booting /pci@1f,0/pci@1,1/network@c,1/netbsd
3028754@0x1000000+219984@0x1400000+433440@0x1435b50 
symbols @ 0xfefa4300 74+242976+125598 start=0x1000000
chain: calling OF_chain(800000, ef18, 1000000, fffc5a80, 18)
[ preserving 369424 bytes of netbsd ELF symbol table ]
pmap_bootstrap: could not claim physical dseg extention at fca0000 size 360000
consinit()
setting up stdin
stdin instance = fffb79e0
setting up stdout
stdout instance = fffb7718
stdout package = f007d5f0
console is unknown
Copyright (c) 1996, 1997, 1998, 1999, 2000
The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California.  All rights reserved.
	
NetBSD 1.5 (GENERIC) #14: Wed Nov 22 10:44:31 PST 2000
eeh@nonplus.one-o.com:/home5/src/src/sys/arch/sparc64/compile/GENERIC
total memory = 256 MB
avail memory = 226 MB
using 1651 buffers containing 13208 KB of memory
bootpath: /pci@1f,0/pci@1,1/network@c,1
mainbus0 (root): SUNW,UltraAX-i2
cpu0 at mainbus0: SUNW,UltraSPARC-IIe @ 500 MHz, version 0 FPU
cpu0: physical 4K instruction (32 b/l), 4K data (32 b/l), 8192K external (64 b/l) 
pcons0 at mainbus0
No counter-timer -- using %tick at 500MHz as system clock.
Using tick -- intr in 5000000 cycles...done.
raidattach: Asked for 4 units
Kernelized RAIDframe activated
root device: 
use one of: raid0[a-h] raid1[a-h] raid2[a-h] raid3[a-h] halt
root device: