On Mon, Dec 22, 2003 at 10:43:33AM +0000, Julian Coleman wrote:
> Tried an MP kernel (1.6ZF) on my 20 yesterday.  It dies after the "booting
> secondary processors" message (see output below).  Anyone else see this?
> 
> If I run it with a UP kernel (same vintage), it's fine as long as I don't
> do anything on the X display attached to the cg14 (Xsun24: cg6 is :0.0,
> cg14 is :0.1).  When I do, it dies with a "level 15 interrupt" or "kernel
> fault" within a few minutes (with no trace).  Bad hardware?  It used to run
> 1.6K UP, so I don't think it's a hardware problem, but I could be wrong.
> 
> ...

Be sure you have sys/kern/kern_lock.c rev. 1.74
-- 
Juergen Hannken-Illjes - hannken@eis.cs.tu-bs.de - TU Braunschweig (Germany)