On Sun, 19 Jan 2003, matthew green wrote:
> you mean that it probed 'cpu0: ... & cpu1: ...' but when it came to saying
> 'cpu0: booting secondary processors: cpu1' it didn't say cpu1?  that, from
> what i read of the code, shouldn't be possible...

	cpu0 at mainbus0: mid 8: TMS390Z50 v1 @ 40 MHz, on-chip FPU
	cpu0: physical 20K instruction (64 b/l), 16K data (32 b/l): cache enabled
	cpu1 at mainbus0: mid 10CPU did not spin up
	: TMS390Z50 v1 @ 40 MHz, (null) FPU
	cpu1: physical 20K instruction (64 b/l), 16K data (32 b/l):
	...
	cpu0: booting secondary processors:

Hum, "CPU did not spin up"...?


 - Hubert


P.S.: Trying today's -current (after nathan_sw merge) GENERIC.MP, I get:

	Using BOOTP protocol: ip address: 10.0.0.12, netmask: 255.255.255.0, gateway: 10.0.0.3
	root addr=10.0.0.3 path=/home/zicke/root
	kernel too large: 3671688 (maximum kernel size is 3670016)
	device[/iommu@f,e0000000/sbus@f,e0001000/ledma@f,400010/le@f,c00000] ("halt" to halt): halt

      Same with latest boot.net.

-- 
Want to get a clue on IPv6 but don't know where to start? Try this:
* Basics -> http://www.onlamp.com/pub/a/onlamp/2001/05/24/ipv6_tutorial.html
* Setup  -> http://www.onlamp.com/pub/a/onlamp/2001/06/01/ipv6_tutorial.html
Of course with your #1 IPv6 ready operating system -> http://www.NetBSD.org/