On Tue, Feb 20, 2001 at 04:55:25PM -0500, Jason Wright wrote:
> On Tue, Feb 20, 2001 at 01:43:15PM -0500, Rob Quinn wrote:
>>  http://www.netbsd.org/Ports/sparc/hardware.html says the qfe card is
>> supported, though "not well tested". I don't see mention of it in the
>> INSTALL or GENERIC conf files. How do I enable mine?
> It's just a matter of adding SUNW,qfe as another name for the sbus hme driver
> to match.  Looks like it only matches this in NetBSD:
> 	SUNW,hme

 Thanks. I inserted an extra strcmp to hmematch_sbus in dev/sbus/if_hme_sbus.c
and that did it. No problems so far, but I've only been running it for a few
minutes, and only at 10baseT. The fact that it now comes up as hme instead of
qfe might surprise people migrating from Solaris.

hme0 at sbus0 slot 1 offset 0x8c00000 level 4 (ipl 7): address 08:00:20:82:32:64
ukphy0 at hme0 phy 1: Generic IEEE 802.3u media interface
ukphy0: OUI 0x00601d, model 0x000c, rev. 1
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme1 at sbus0 slot 1 offset 0x8c10000 level 4 (ipl 7): address 08:00:20:82:32:64
ukphy1 at hme1 phy 1: Generic IEEE 802.3u media interface
ukphy1: OUI 0x00601d, model 0x000c, rev. 1
ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme2 at sbus0 slot 1 offset 0x8c20000 level 4 (ipl 7): address 08:00:20:82:32:64
ukphy2 at hme2 phy 1: Generic IEEE 802.3u media interface
ukphy2: OUI 0x00601d, model 0x000c, rev. 1
ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
hme3 at sbus0 slot 1 offset 0x8c30000 level 4 (ipl 7): address 08:00:20:82:32:64
ukphy3 at hme3 phy 1: Generic IEEE 802.3u media interface
ukphy3: OUI 0x00601d, model 0x000c, rev. 1
ukphy3: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto