On Fri, 8 Dec 2000, Andrei Petrov wrote:

> 
> I tried to turn on all parity checks and disabled disconnect
> feature in IDENTIFY message. Now I'm getting SCSI parity error
> after first byte is sent to device. I tried to play with different
> config registers settings, no diffrence what so ever(doesn't mean I tried 
> all possible combination, primaraly it was around FASTCLOCK, FASTSCSI).
> 

I set dma-parity off and now they (controller/disk) exchange messages
again. But I still see no data in REQUEST_SENSE. And INQUIRY failed
totally, drive disconnected on step 0 which is selection timeout.

I made driver pretty verbose, can it cause problems? Like extra
delays. I have to check.

> Thanks again,
> 	Andrey
> 
>