On Sun, Nov 23, 2003 at 11:47:43AM +0900, Christopher SEKIYA wrote:
> On Sat, Nov 22, 2003 at 09:09:53PM +0100, Vladimir Kotal wrote:
> 
> > This problem can be reproduced, every time I tried to install this
> > snapshot, machine freezed while making device nodes.
> 
> "Freeze" as in "hitting enter a few times doesn't show anything on the
> console", or "freeze" as in "zero activity whatsoever"?

The second case. Trying to switch numlock on and off with null results.
Also, the power button on front panel is not working, had to plug out power
cable.

> 
> > 1.6.1 installs fine and it also detects L2 cache for R5k.
> 
> Detects but disables L2.  However, if this were a L2 botch it should have
> died before it spawned sysinst.  It wouldn't be 100% reproducible.
> 

Hm, yes. After I tried it again, it "freezed" elsewhere.

> > 20031120 snapshot also failed to detect disk geometry right, whereas 1.6.1
> > seems to detect it w/out problem.
> 
> This bit is due to scsipi changes in -current, and appears to be harmless (I
> see it on my r5k ip32).
 
Ok. Setting it by hand worked for me.

> I've just performed a complete install on my ip24.  No problems whatsoever.
> 

I finally installed 1.6.1, this seems to be stable (survived kernel build,
cvs update of src tree, etc.)

> Please send the output of "hinv -t" and the installation kernel dmesg.
> 

System: IP22
Processor: 150 MHz R5000, with FPU
Primary I-cache size: 32 Kbytes
Primary D-cache size: 32 Kbytes
Secondary cache size: 512 Kbytes
Memory size: 160 Mbytes
Graphics: GR3-XZ
SCSI disk: scsi(0)disk(1)
Audio: Irix Audio Processor: version A2 revision 4.1.0

PROM version:
PROM monitor SGI Version 5.3 Rev B10 R4X00/R5000 IP24 Feb 12, 1996 (BE)  


This is the previous kernel:

Using ARCS for console I/O.
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.6.1 (GENERIC_INDY) #0: Wed Apr  9 00:52:12 UTC 2003
    autobuild@tgm.daemon.org:/autobuild/netbsd-1-6/sgimips/OBJ/autobuild/netbsd-1-6/src/sys/arch/sgimips/compile/GENERIC_INDY
160 MB memory, 143 MB free, 768 KB for ARCS, 8292 KB in 2073 buffers
mainbus0 (root): SGI-IP22 [SGI, 6906df6d], 1 processor
cpu0 at mainbus0: MIPS R5000 CPU (0x2310) Rev. 1.0 with built-in FPU Rev. 1.0
cpu0: 32KB/32B 2-way set-associative L1 Instruction cache, 48 TLB entries
cpu0: 32KB/32B 2-way set-associative write-back L1 Data cache
cpu0: 512KB/32B direct-mapped write-back L2 Data cache
cpu0: disabling IP22 SysAD L2 cache
imc0 at mainbus0 addr 0x1fa00000
imc0: Revision 3
gio0 at imc0
hpc0 at gio0 addr 0x1fb80000: SGI HPC3
zsc0 at hpc0 offset 0x59830
zstty0 at zsc0 channel 1
zstty1 at zsc0 channel 0
sq0 at hpc0 offset 0x54000: SGI Seeq 80c03
sq0: Ethernet address 08:00:69:06:df:6d
wdsc0 at hpc0 offset 0x44000: WD33C93B SCSI, rev=0, target 7
scsibus2 at wdsc0: 8 targets, 8 luns per target
dsclock0 at hpc0 offset 0x60000
biomask 07 netmask 07 ttymask 0f clockmask bf
scsibus2: waiting 2 seconds for devices to settle...
sd0 at scsibus2 target 1 lun 0: <SEAGATE, ST15150N, HP03> SCSI2 0/direct fixed
sd0: 4095 MB, 3712 cyl, 21 head, 107 sec, 512 bytes/sect x 8388315 sectors
sd0: sync (200.0ns offset 12), 8-bit (5.000MB/s) transfers
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs


And this is netbsd-GENERIC32_IP2x from 20031120 snapshot:


Using ARCS for console I/O.
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.6ZF (GENERIC32_IP2x) #0: Thu Nov 20 13:05:58 JST 2003
	wileyc@izu:/usr/builder/sgimips-rel/obj/sys/arch/sgimips/compile/GENERIC32_IP2x
160 MB memory, 143 MB free, 768 KB for ARCS, 8292 KB in 2073 buffers
mainbus0 (root): SGI-IP22 [SGI, 6906df6d], 1 processor
cpu0 at mainbus0: MIPS R5000 CPU (0x2310) Rev. 1.0 with built-in FPU Rev. 1.0
cpu0: 32KB/32B 2-way set-associative L1 Instruction cache, 48 TLB entries
cpu0: 32KB/32B 2-way set-associative write-back L1 Data cache
imc0 at mainbus0 addr 0x1fa00000
imc0: Revision 3
gio0 at imc0
hpc0 at gio0 addr 0x1fb80000: SGI HPC3
zsc0 at hpc0 offset 0x59830
zstty0 at zsc0 channel 1
zstty1 at zsc0 channel 0
sq0 at hpc0 offset 0x54000: SGI Seeq 80c03
sq0: Ethernet address 08:00:69:06:df:6d
wdsc0 at hpc0 offset 0x44000: WD33C93B SCSI, rev=0, target 7
scsibus0 at wdsc0: 8 targets, 8 luns per target
dsclock0 at hpc0 offset 0x60000
haltwo0 at hpc0 offset 0x58000: HAL2 revision 4.1.0
audio0 at haltwo0: half duplex
biomask 07 netmask 07 ttymask 0f clockmask bf
scsibus0: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 1 lun 0: <SEAGATE, ST15150N, HP03> disk fixed
sd0: 4095 MB, 3712 cyl, 21 head, 107 sec, 512 bytes/sect x 8388315 sectors
sd0: sync (200.00ns offset 12), 8-bit (5.000MB/s) transfers
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs


I ran kernel build (over 1hour time :)) and several port builds on this kernel 
and it seems to be pretty stable. I also tried to extract some bigger .tgz 
files (softupdates on) and system is still running :)


And finally the install kernel dmesg :

Using ARCS for console I/O.
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 1.6ZF (INSTALL32_IP2x) #0: Thu Nov 20 14:23:30 JST 2003
	wileyc@izu:/usr/builder/sgimips-rel/obj/sys/arch/sgimips/compile/INSTALL32_IP2x
160 MB memory, 140 MB free, 768 KB for ARCS, 8292 KB in 2073 buffers
mainbus0 (root): SGI-IP22 [SGI, 6906df6d], 1 processor
cpu0 at mainbus0: MIPS R5000 CPU (0x2310) Rev. 1.0 with built-in FPU Rev. 1.0
cpu0: 32KB/32B 2-way set-associative L1 Instruction cache, 48 TLB entries
cpu0: 32KB/32B 2-way set-associative write-back L1 Data cache
imc0 at mainbus0 addr 0x1fa00000
imc0: Revision 3
gio0 at imc0
hpc0 at gio0 addr 0x1fb80000: SGI HPC3
zsc0 at hpc0 offset 0x59830
zstty0 at zsc0 channel 1
zstty1 at zsc0 channel 0
sq0 at hpc0 offset 0x54000: SGI Seeq 80c03
sq0: Ethernet address 08:00:69:06:df:6d
wdsc0 at hpc0 offset 0x44000: WD33C93B SCSI, rev=0, target 7
scsibus0 at wdsc0: 8 targets, 8 luns per target
dsclock0 at hpc0 offset 0x60000
haltwo0 at hpc0 offset 0x58000: HAL2 revision 4.1.0
audio0 at haltwo0: half duplex
biomask 07 netmask 07 ttymask 0f clockmask bf
md0: internal 3072 KB image area
scsibus0: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 1 lun 0: <SEAGATE, ST15150N, HP03> disk fixed
sd0: 4095 MB, 3712 cyl, 21 head, 107 sec, 512 bytes/sect x 8388315 sectors
sd0: sync (200.00ns offset 12), 8-bit (5.000MB/s) transfers
boot device: sd0
root on md0a dumps on md0b
WARNING: clock gained 3 days -- CHECK AND RESET THE DATE!
root file system type: ffs


v.