Yes, correctly, I took out the ex card, and inserted the fxp card the same
slot and used the same cable to hub.

And I inserted following 2 lines in MYGENERIC.

fxp*    at pci? dev ? function ?        # Intel EtherExpress PRO 10+/100B
inphy*  at mii? phy ?                     # Intel 82555 PHYs

Initial procedures were just same as ex card, device detection, initial and
mac address reading.


----- Original Message -----
From: "Allen Briggs" <briggs@wasabisystems.com>
To: <port-sandpoint@netbsd.org>
Sent: Thursday, August 09, 2001 11:50 PM
Subject: Re: fxp0: device timeout


> > I succeeded to attach ex0, 3c905B pci lan card, I said.
>
> Great!
>
> > Now, I'd like to change this to intel etherexpress-pro(fxp).
>
> I haven't actually tried this card, myself.
> The 'device timeout' message is usually an interrupt problem.  Is
> the fxp in the same PCI slot that the ex was?
>
> -allen
>
> --
>  Allen Briggs                     briggs@wasabisystems.com
>  http://www.wasabisystems.com/    Quality NetBSD CDs, Sales, Support,
Service
> NetBSD dev. for _your_ Alpha, ARM, M68K, MIPS, PowerPC, SH3, Sparc, x86,
etc...
>