Matt Thomas wrote:

> At 04:17 PM 2/10/2004, you wrote:
> >Matt Thomas wrote:
> >
> > > At 02:44 PM 2/10/2004, Kate Feng wrote:
> > > >Matt Thomas wrote:
> > > >
> > > > > On Thursday, October 2, 2003, at 10:07 AM, Kate Feng wrote:
> > > > >
> > > > > > Hello,
> > > > > >
> > > > > > I am looking for BSD device drivesr written for the Marvell GT64260B
> > > > > > system
> > > > > > controller.  I found some traces talking about support for the
> > Marvell
> > > > > > GT64260
> > > > > > Evaluation Board.  However, I  could not find the software.  I am new
> > > > > > to
> > > > > >
> > > > > > netBSD.....Sorry.
> > > > >
> > > > > Support for it is in NetBSD-current:
> > > > >
> > > > > sys/arch/evbppc/ev64260
> > > > > sys/arch/powerpc/marvell
> > > > > sys/dev/marvell
> > > > > --
> > > >
> > > >Are those codes fully tested , especially for the 10/100 M
> > > >ethernet on the GT64260 ?
> > > >One particular file I looked at is the sys/dev/marvell/if_gfe.c.
> > >
> > > The datasheet is wrong.  It took me a week of analysis to figure
> > > out the exact algorithm.
> > >
> >
> >Is the code really tested ?  I do not see any makefile associate
> >with the if_gfe.c.
>
> Yes.  I've used it for nearly 3 years.
>

Again, I  had no previous experience with netBSD.   Why  are'nt
there any  makefile associated with the files in the sys/dev/marvell
directory which I got from
tftp://ftp.NetBSD.org/pub/NetBSD/NetBSD-current/   ?   Is this
how netBSD archive its source codes ?  Perhaps I am missing
something.

I saw the file  if_gfe.c was updated  last Aug  5 .  Do you
know what was changed ?  Do you mind sending me your
version of source codes (including makefiles) that you claimed  it
worked for nearly three years ?

Any assistance is highly appreciated.

Respectfully,
Kate