At 07:06 PM 11/2/99 , Chris Tribo wrote:
>     I know this isn't the right place to be asking about it but I can't sem
>to find any information other than the fact that there is something called
>ELMS for Ultrix that administrates this bridge. I searched both Compaq and
>Digital's web site for about an hour and didn't find one shred of
>information other than the fact that it is Y2K compliant. I'm trying to use
>if to go from BNC 10Base2 on my 5000/200 to 10BaseT on the rest of my
>network. So far I can't seem to get anything in or out of the DECstation,
>the BNC activity light comes on when the bridge wakes up from no activity
>for about five seconds then doesn't come on again. Any ideas where I can
>find info/manuals/software/source code/anything? Thanks in advance

did you look at cabletron?  I'd be surprised if it was setup to block ip.
-- 
Matt Thomas               Internet:   matt@3am-software.com
3am Software Foundry      WWW URL:    http://www.3am-software.com/bio/matt/
Cupertino, CA             Disclaimer: I avow all knowledge of this message