To all those who stood up and shouted in unison "the mouse isn't
plugged in properly", take a bow.  Thanks to all who helped.

Peter 

Simon Burge wrote:
> 
> On Fri, 18 Apr 1997 18:19:49 +1000  Peter Davie wrote:
> 
> > I have a DECstation 5000/120 and I am hoping to run NetBSD on it. There
> > are two problems with it, the first is that during its power on self
> > test, the message
> >
> > ?STF (4: Ln#1 Pntr self test)
> >
> > appears.  What does this message mean?
> 
> This means you don't have a pointer (mouse) plugged in (or it wasn't
> detected).  If you're using a serial console, it's nothing to worry
> about.  If you are using a serial console, you probably also got a
> similar message about Kbd as well as Pntr.
> 
> Otherwise, either your mouse or one of the serial ports may not be
> working.  From the "Ln#1" above I'd guess the mouse was on the second
> serial controller (scc1).  This could tie in with you getting no further
> than scc0 (the first serial controller).
> 
> > The second problem is that when I remote boot using BOOTP from a Sun
> > running Solaris 2.5.1, NetBSD 1.2 (Wed Sep 18 07:00:55 PDT 1996)
> > gets as far as the line
> > scc0 at asic0 offset 0x100000 priority 6
> >
> > and then comes to a dead halt.
> >
> > Any thoughts?
> 
> The serial console is on scc0, so if you aren't using a serial console,
> you could try that.  When was the last time you used Ultrix on the
> machine?
> 
> Simon.

-- 
Peter Davie		Phone:	+61 6 257 6500	e-mail:	pdavie@netinfo.com.au
Director		Fax:	+61 6 257 8922	snail:	PO Box 53
topic Systems Australia	http://www.netinfo.com.au/tsa	Lyneham ACT 2602
1 Hall Street, Lyneham ACT 2602