On Nov 28,  8:19pm, Erik Bertelsen wrote:
> If the 5000/25 has the same console commands as a 5000/1xx, there is a
> "scsi" command with two letter sub-commands to reset, test, etc. the
> bus or single drives. You can status sense and in fact start commands
> to single disk units on the bus.

  Doing a ? doesn't list a "scsi" command, but does list a "t" command.
I have a DS5000 Model 100 Series Operator Guide which also shows the "t"
command.  I did a "t 3/?" to get a list of the tests available, and there
were 3 "scsi/*" tests.  One test was "scsi/target", so I tried entering
	"t 3/scsi/target 0"
	"t 3/scsi/target 1"
	"t 3/scsi/target 2"
and those appeared to spin up the disks which weren't configured to spin up
on power on.

Michael

-- 
Michael L. Hitch			INTERNET:  mhitch@montana.edu
Computer Consultant
Information Technology Center
Montana State University	Bozeman, MT	USA