Subject: Re: beige g3
To: Tim Kelly <hockey@dialectronics.com>
From: John <jhu@grex.cyberspace.org>
List: port-macppc
Date: 04/30/2005 11:40:52
Hi,
I've tried that as well. I can probe what resolutions it supports in
openfirmware. Unfortunately, it only lists 640x480x8.
-John
On Sat, 30 Apr 2005, Tim Kelly wrote:
> On Fri, 29 Apr 2005 20:43:39 +0000 (UTC)
> Johnny <jhu@sdf.lonestar.org> wrote:
>
> > Hi,
> >
> > I noticed that your beige g3 has ofb0 set to 1024x768x8. I was
> > wondering how you were able to do that because I can't seem to get
> > anything beyond 640x480x8 on my beige g3 (revision 1 with ati rage
> > II+). Thanks.
> >
> > -John
>
> On my AGP G4, while in Open Firmware, I change the resolution by the
> following:
>
> dev screen
> 1d set-mode
>
> I then boot as I would normally. The above requires some basic Open
> Firmware to be on the card, and not all display cards have this. To
> find out if your display can support changing the resolution in OF,
> after the dev screen command, do
>
> see words
>
> and look for set-mode, show-modes, and mode#. Show-modes will list
> possible resolutions. The mode number must preceed the set-mode
> command.
>
> Usually once I've set the resolution in OF I don't have to change
> it again. Your mileage may vary.
>
> tim
>