On Wed, Apr 06, 2005 at 11:43:27AM -0700, Tomas D wrote:
>  Hi,
> I got Seagate ST32171W drive
> (http://www.seagate.com/support/disc/scsi/st32171w.html)
> before I put it in my 9500/200 mac:
>  1) I set SCSI ID to 1 using front jumper (my other
> drive is located on scsi-int/sd@0:0), 
>  2) set J2 jumper on harddisk board to "Enable motor
> start"(the drive waits for the start unit command from
> the host before starting spindle motor)
> Apply power to my mac and boot:
> Open Firmware, 1.0.5
> To continue booting the MacOS type:
> BYE<return>
> To continue booting from the default boot device type:
> BOOT<return>
>  ok
> 0 > boot scsi-int/sd@0:0
>         (stopped for a bit)
> 0 > boot scsi-int/sd@0:0  can't OPEN: scsi-int/sd@0:0
>  ok
>         (trying again)
> 0 > boot scsi-int/sd@0:0 RESETing SCSI bus
> 
> OF_open bootpath=scsi-int/sd@0
> read stage 2 blocks: 0123456. done!
> starting stage 2...
> 
> >> NetBSD/macppc OpenFirmware Boot, Revision 1.10
> >> (builds@build, Wed Dec  1 13:46:04 UTC 2004)
> 4435240\
> 
> So my mac boots up and right where information about
> drives on dmesg is:
> scsibus0: waiting 2 seconds for devices to settle...
> scsibus1: waiting 2 seconds for devices to settle...
> sd0 at scsibus1 target 0 lun 0: <QUANTUM, FIREBALL
> SE3.2S, PJ0A> disk fixed
> sd0: drive offline
> mesh0 target 1: rejecting extended message 0x1
> mesh0: unexpected disconnect

Unfortunably it doesn't say the code of the extended message which was
rejected. But I suspect a problem with mesh(4).
Can you try to disable disconnect/reselect in the kernel config ?

-- 
Manuel Bouyer <bouyer@antioche.eu.org>
     NetBSD: 26 ans d'experience feront toujours la difference
--